Side mirror turn signal lights

Urghh. Okay thanks....but which wire to tap into again? lol

 

Wow I ordered the light coming from Japan last Friday and it was shipped out yesterday (Sunday for us but Monday for Japan). Today tracking said it’s in Chicago. Looks like it’ll be here in a couple days. That’s FAST!!!
that’s faster than some stuffs I ordered from US sellers.
I also ordered a black steering wheel appliqué from China over three weeks ago. It’s still going...lol

 

Just keep in mind if you go that route, you'll have to provide your own cabling between the lamps and ECU, the mid connector between the door and body might be interesting to bypass, I think you could sneak a few wires through without using the connector pinout.

I think getting this third party part is much cheaper and easier given all the parts

 

Got the lights today. Wow, 3 days shipping time. Coming straight from Japan. Unreal.
Looks like it’ll be a busy weekends

 

I finally got my puddle lights wired up and posted a full thread here

Avest Side Mirror install | PriusChat

 

I just started this journey, to install sequential turn signal mirror lights with puddle lights and running lights on my 2017 Prius Prime Advanced model. Here is my purchase from Ebay:

For Toyota Camry C-HR Prius XW50 Mirror Dynamic Turn Signal Light | eBay

This thread is going to be quite useful for me to do a self-install.

For my contribution to this thread, I have discovered an easy way to run the wires from the passenger side of the dash over to the driver's side. There is a structural member running through the entire dash, from side to side horizontally. I'm not sure if this beam, in the form of a "pipe" is to provide lateral structural stability for the vehicle or to provide crash protection, but since the tube is open on both ends, it makes for an easy conduit tube for getting wires from the passenger side to the driver's side. Open both doors, pop off the side panel on the dash on both sides, and then just feed all necessary wires with a wire fish through the pipe, and voilá! You've just saved a bunch of time upside down under your dash threading wires over to the driver's side! I'm pretty sure all this would apply to the regular Prius as well.

Supplied 3 lead running light and turn signal wire fished on passenger side. I still have to fish the puddle light wires and the sequential on/off switch wires:



Supplied 3 lead running light and turn signal wire fished on driver's side. I still have to fish the puddle light wires and the sequential on/off switch wires:


It took me mere minutes to do this. What a timesaver!

If the wires end up rattling inside the pipe, I'll just wrap the whole wire bunch in small diameter pipe insulation and re-feed them through the pipe. Easy-peasy!