1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Poll: BT Tech Stiffening Plate

Discussion in 'Gen 2 Prius Accessories & Modifications' started by Swanny1172, Jun 5, 2007.

?

BT Tech Stiffening Plate

  1. I would definitely buy one again.

    16 vote(s)
    50.0%

  2. I would probably buy one again.

    10 vote(s)
    31.3%

  3. I am unsure if I would or would not buy one again.

    3 vote(s)
    9.4%

  4. I would probably not buy one again.

    2 vote(s)
    6.3%

  5. I would definitely not buy one again.

    1 vote(s)
    3.1%
Page 4 of 4
  1. fruzzetti

    fruzzetti Customization-Obsessed

    Joined:
    Dec 5, 2007
    377
    6
    0
    Location:
    California (Pulled over 6x, ticketed 2x for tint)
    Vehicle:
    2006 Prius
    Model:
    N/A
    I don't know if that's the best logic. Yes, the price is a bit high, but compared to large outfits it's a low-volume run of the things. I haven't opened mine yet. I'm planning on installing it this afternoon.

    I'll say this much: two tiny pieces of square tube steel ten inches long each were the final reason the rear end of my mustang stopped getting out from under me; the suspension and sway bars cleared out a lot of it, but the "final answer" was the stiffening connectors... I hope the Prius gets the same boost.

    I notice right now the car has a bit of understeer under hard cornering conditions (or at least it DID with the stock tires; now I have Continental 205/60s); I will try to see if this is different or the slip occurs at a different time.

    ~ dan ~
     
    #61 fruzzetti, Dec 22, 2007
(You must log in or sign up to post here.)
Page 4 of 4