1. Attachments are working again! Check out this thread for more details and to report any other bugs.

06 prius transmission problem? I dont get it

Discussion in 'Gen 2 Prius Technical Discussion' started by kberven65, Aug 23, 2015.

Page 2 of 2
  1. kberven65

    kberven65 New Member

    Joined:
    Aug 23, 2015
    24
    0
    0
    Location:
    pierre sd
    Vehicle:
    2006 Prius
    Model:
    N/A
    Had codes read at the dealer. No codes besides a cylinder 4 misfire. Which also threw an p0138. Everything else was fine. Stuck valve?
     
    #21 kberven65, Aug 25, 2015
  2. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,525
    8,428
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    how many miles on this engine? are you sure this new engine is good? Not one that was replaced because it was bad?
     
    #22 JC91006, Aug 25, 2015
  3. kberven65

    kberven65 New Member

    Joined:
    Aug 23, 2015
    24
    0
    0
    Location:
    pierre sd
    Vehicle:
    2006 Prius
    Model:
    N/A
    It ran fine for a couple hours before it started acting up. That's what I don't get. Drove it 100 miles yesterday to see if I'd come out of it and it didn't.
     
    #23 kberven65, Aug 25, 2015
  4. kberven65

    kberven65 New Member

    Joined:
    Aug 23, 2015
    24
    0
    0
    Location:
    pierre sd
    Vehicle:
    2006 Prius
    Model:
    N/A
    Was a engine pulled out of a salvage vehicle
     
    #24 kberven65, Aug 25, 2015
  5. kberven65

    kberven65 New Member

    Joined:
    Aug 23, 2015
    24
    0
    0
    Location:
    pierre sd
    Vehicle:
    2006 Prius
    Model:
    N/A
    120k on new engine
     
    #25 kberven65, Aug 25, 2015
  6. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,525
    8,428
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    swap the coil on cylinder #4 to another cylinder, see if the misfire goes with the coil. Since your spark plugs are new, I would hope they are good
     
    #26 JC91006, Aug 25, 2015
(You must log in or sign up to post here.)
Page 2 of 2