Separate names with a comma.
Looks like I'll be investing in a scanner now being that my car is 11 years old and @ 195k. Would I be better off with the scanner or that other...
Ok, so is it possible that my voltages weren't matched closely enough before I put the pack into the vehicle, or could the pack's voltage be too...
I was driving along and the red triangle appeared. Everything continued to operate as normal until I turned the vehicle off and then the ICE...
Ok, now I'm stranded in the car, and the ICE won't come on at all. I don't have a code reader. Red triangle and problem message. Is there anything...
I performed the battery drain test and here is my result. 5:55 before ICE began charging HV battery = 5.917 minutes 5.917 * 9.5% = 56.21 A...
Battery is in the car, and 75 miles later everything is still going great. It seems to be good. I'll know in another 75 miles whether or not I...
It has taken no less than 2 minutes for any of the modules to reach 7.75, but they're all rising again after a few minutes and the resting...
Finally got the pack back together. Man, what a pain! Had to remove the electronics from end of the pack and use some pipe clamps to hold them...
One more thing before I reassemble. I've read that the modules should be placed adjacent to other modules with comparable capacity. How important...
Awesome, Keith. Thanks for the advice. I'll do the discharge method with the X4 as you suggested. I actually prefer this method because I'm...
I'm only following the example from other people I've seen in this thread, which has always been hooking the pack up in parallel to balance...
So everything is looking good so far. A couple of questions though: I thought 3 modules needed replacement, but I was able to do additional...
So does that mean I must use 0.7A for discharging to reach the desired level of discharge? What are the implications of using 1A? Please pardon my...
Everything is still working well and my discharge results look pretty good on the first 4 modules after 3 cycles, over 5,200 mAh. Quick question,...
Voltage was 11.74 with all 4 channels running at 5A.
Thanks for the replies, fellas. So I modded the other PSU, and wouldn't ya know it, it handles all 4 channels @ 5 amps no problem. It actually...
I'm not sure I'm getting the full 12V, but I took all of the yellow wires and bound them together. The initial measurement is 11.3 with the Hitec...
I just checked, and all channels were set to 10V. I tested the voltage drop, and sure enough, it's dips below 10V. I adjusted the amperage, and...
It was already set to 10V. I've got a second PSU that I can modify, is it possible to run the 2 supplies together to power the X4? Perhaps I can...
Thanks for the response, Keith. Unfortunately, I'm stuck with the X4 bc I bought it on eBay and have clipped one of the cable sets to crimp on a...
