Separate names with a comma.
You loosen the T30 screw under the quarter sized black plastic cover then pull the cylinder out. The screw has keepers so it will not fall...
When doing ANY smartkey work, make sure the batteries and buttons on all fobs are good (does LED light up when you press each button). When doing...
You should not have to buy a new ECU. Gen3 Seed reset should do it if you lost all keys. If someone "bricked" the car by pressing power button...
Easy to test. Roll down drivers window. From outside reach in and hit lock button on drivers armrest. Walk around car and check doors. Did all...
Every car owner should have two working keys for their car. Then if you lose one you still have a backup and can easily make more. If you lose...
Deja, before you spend money solving the 12V problem borrow a 12V battery (any kind) and jumper cables then have the car thoroughly checked out....
Old spark plugs can make the engine sound horrible and run rough. [MEDIA] Plugs are supposed to be changed at 120k miles. I like Denso Irridium...
If the AC evaporator under the dash has failed, that's a really big job. The entire dash has to come out to replace the unit (BTW it's not called...
For Gen3 you can buy new fobs on Ebay or "virginized" or "reset" used fobs. They can then be programmed yourself with Mini-VCI or Techstream....
If you register new FOB to a Gen3 after the passcode seed reset but before pressing power button 10 times it is no problem. If you press the...
Jenrommel, Print this out and take it to the most senior tech at the dealer. You do not need a new ECU. You may need a more experienced...
If you have Techstream/MiniVCI you can program new (or virginized) fobs yourself. If they are used FOBs you need a passcode calculated and "seed...
Easiest way to upgrade Gen1 radio is to install any 1 DIN radio in the pocket below the HVAC controls. Radio Auxiliary Install? | PriusChat If...
Any decent shop has a TPMS scanner that will confirm sensors are working and extract the ID code of each sensor via RF. (they walk around the car...
As of Sept 2015 "new" Gen1 packs from the dealer all contain modules that look like Gen1 modules (plastic sides, slightly smaller than Gen2...
I have not seen a DIY full "bolt in" kit for Gen1. Too few Gen1s were sold to make it worthwhile for aftermarket vendors. You can remove the...
Uhm all you need to do is fill the tank, the gas gauge will calibrate itself once full. Dropping the tank is a waste of time. You cannot...
There is no way to delete an individual fob. Basically the system deletes all fobs but the one you have in the dash then you re-add the ones you...
While DRLs are great where you need them (northern countries, rainy places) some people don't want them on all the time. The Gen1 Prius...
Toyotadam, are you sure you have a master key for that car? i.e. does the Security LED go off immediately when you insert the key into the...
