Separate names with a comma.
Hi John - after reading all the posts from the beginning I would like to make a comment on the charge and discharge capacity of these modules - in...
This is very good advice Brad - I was testing a battery that I had converted from G! to G2 cells - the battery was not rehydrated and I was...
Roy from Canada here : Thanks to strawbrad who referred us to a this post by Jeff K - this man did his experiment with boiling water and...
John the red pads are very thin O,13 mm thick and appear to be a type of plastic tape that runs around the battery - I pulled a piece off to...
Hi John - I will measure the pads tomorrow and report. I had drained all the fluid out of the one cell I used to give my original ml readings -...
John I have bad news about the amount of water to fill the cells, I was using measuing spoons and must have not filled the spoons to the top each...
High Eric - I have a high voltage charger/discharger I made, however it does not have the ability to calculate the capacity of charge or...
Thanks Chap - I should have said my cars readings were usually 18 ot 19 milliohms (not micro). that would make each module around 8.5 to 9...
Good thinking - The steel syringe needle could go too deep and cause a problem.I have edited my post to include your suggestion. Alex - did you...
I read the post by jeffkay and found this paragraph from the post very interesting as it got him 20000 miles of driving --- xxx "Small holes are...
It will but the discharge capacity is very low and it will take hours to discharge the modules thus making a process that takes days to do 3...
Good that you were communicating with Bob and you decided to carry on the process.
In one car I have G1 modules that I recycled 3 times(over a year ago) and all 38 were in the 3000 to 3500 discharge range. this car has gone...
My other 3 cars have Gen 1 modules in them and they are working OK. It seems it is not how high a discharge capacity the modules have but how...
Hi John - I have made a spare Gen1 battery using Gen 2 modules -installed it a while back -- as long as I drive it around town it has lasted about...
I will try again Hi Brad - Your input is very valuable keep up the good work, I just noted the screws that are in your battery picture are in...
Hi Brad - Your input is very valuable keep up the good work, I just noted the screws that are in the battery picture are in line with the walls of...
10 ml - nothing above top of battery 20 ml - just at the top of the battery 25 ml- 8 mm of water above the battery Note - I did not wait for the...
# 2 Ok - others bad for sure
