Separate names with a comma.
Nice work. I also went with fiberglass, but built mine off to the side. Now I want a ported box, so I'll sell my fiberglass box around Christmas.
The harness should unplug fairly easily. Once it's unplugged you can drill a hole through one of the unused locations on the harness and route...
It's a sealed box. Ported & fiberglass is a bit more challenging to make. Soon I'll have a ported box that covers the entire floor of the hatch,...
I've always used Second Skin because I know it doesn't smell. I know I could save a few bucks using something else, but I'm not willing to take...
I've seen these in person and they look pretty sharp. But so far nobody knows with certainty that the kit will fit an American Prius C. Even...
It is about .6 ft^3. I measured it wuth foam peanuts, but it's the right size for the sub. In August I'll build a new box. Just waiting to get...
No RCA's/co-ax on the deck. But the Bit10 converts and gives the turn on signal and a clear RCA signal and its small enough to hide in the dash....
The only reason I didn't swap out the head unit was to maintain the stock look and all the integrated stuff (blue tooth, back up cam, steering...
Could keep the head unit and go after market amp & speakers and use one of these: Audison Bit10 ($400-500) Audiocontrol DQ-61 ($280-400)...
I did mine over 3 days. The doors can be done very fast, but if you're replacing the door speakers you'll want to do it at the same time (boosting...
I just used scraps of MDF that were left over from the subwoofer box build. But there are nice plastic adapters available for purchase. I didn't...
Here's a door panel after sound deadening and installing the Morel Tempo 6 components. There's also sound deadening inside the door. Use peel and...
There's nothing installed in that space other than foam and the tire jack. Plenty of room for a 10" shallow mount sub while leaving the spare....
Here you can see how the foam sits by the box and the spare is still in place. [ATTACH]
It wasn't too expensive do the box. You need: 2'×2' 3/4" MDF 1'×2' 1" MDF 1 GALLON RESIN CHOPPED mat I think it could be done for $120 and a...
I'll get a picture with the door panel off tomorrow. It's just 3 screws and those upholstery plastic push pins. Remove the window switch and use...
[ATTACH] this is under the carpet. I can get a pic tomorrow. Or check my build thread om here.
And if you're curious as to a shopping list: $300 JL 10TW3-D4 $350 JL XD700/5 $350 Morel Tempo 6 $300 Morel Tempo 6C $500 Audison Bit10 (can get...
Keep your hatch area. Keep your spare.[ATTACH] One good ten does the trick.
The Bit10 is installed inside the dash. A USB cable goes to the glove box and it can be programmed via my tablet. It's pretty sweet, but likely...
