Separate names with a comma.
Yes I tried, I have the latest and greatest. But thanks for the Idea.;)
I checked today, on the most negative lead of the Celllog I have about 40ma with back light off and 45ma with light on. Checked 3 and they appear...
I will let Lopez answer also but you will need to solder this jumper in all of your Celllogs. I used a single strand from a 18ga. wire and it...
I have the Celllogs set to 3.6v and 2.5v. So the low voltage alarm will sound under load when I get near the end of pack capacity, but the resting...
Yes I only have 1 8s Celllog that has a USB. I did this for lowering the cost and I only need the logging feature if I am trying to find a bad...
The canview is reset after each charge. I have it set at 40AH.( That is what my cells are), So there was 6.57AH left in the pack when I competed...
So I went on a "out of gas" test drive over the weekend. Most of the trip was on 35-40 MPH streets with some stop and go at lights. Drove 15 miles...
Thanks for the heads up. I will not see those temps until June around here, so time will tell. I have 72 cells so I have all my celllogs pins full...
I agree that is enough of taxes, That can be done elsewhere. But thanks for the info;). I have not responded on a lot of your posts on different...
The rear floor will no longer fit, I will be making a new cover for the back that the rear cargo mat will go on top of. That will be the last...
What ....19% sales tax! I hope you guys get a lot of services from your government for that. How do you afford to buy anything?
The circuit I made my BMS from had relays on the Negative pin of the celllogs to shut them off when the key is off or charging. I did not do this...
Ok I went for a freeway test drive tonight after work. not optimal conditions by any means. Car had been sitting all day. I reset trip screen on...
I am guessing that you are wondering if I get false alarms from the Celllogs with the electrical noise? I have driven in out of gas mode up to...
I based my alarm circuit off of the image below found here DIY Electric Car Forums Based on the charger I ended up getting I could eliminate a...
Well, work has kept me busy and have been short on time, but I finally finished wiring up my BMS. I still need to clean up some of the wiring but...
Sorry I have been gone for a little bit, but nice work on the boxes;). How thick are the side pieces, maybe 13mm?
Yes Dan I would like to have done the Mini BMS or Pacific system, But at about $900 for that many cells I thought it was a little too much. I...
To some up the BMS. The master board has 2 connectors on the left. 3 pin has 2 power inputs (one 12v key on. one 12v from a/c power source when...
As Flaninacupboard put it, after charging the voltage drops and after applying a load will drop lower.
