Separate names with a comma.
Been trying this for a while. I bought this at auction from the NY City fleet. The car would not start, then the car somehow started for me twice,...
I've been working the past few days. Hoping to look at it again Friday to try and figure this out
7 or 8 times. Intermittent though. It would start, not start, then start again. Sometimes, during a no start, the dash would fully light up, I...
I had it running for about a half hour in the driveway. It will not lock into park, and the transmission seems screwed (gear related clunk and...
I used a scangage 2, no codes found
I charged it. I also made sure there was more than 12 volts at the underhood fuse box, and I checked all the underhood fuses for 12v on both sides...
Step on the brake, the brake lights go on, and I hear the lovely moaning/grinding noise from the pump. The headlights work, the power windows...
I purchased this Prius about 2 months ago from auction, it was a municipal vehicle. I messed with it, and now I have a no start. Here we go. After...
Ok. I'll have to ohm out the wires (none of the tabs were broken off as I did check that). I did not test the relays, I just swapped out the...
I recently purchased this 03. I was forced to purchase a scangage 2 to read the codes. I cleared them, and it was fine for about 20 miles. After...
Looks like I have to tackle this on a 2003 Prius. I saw the basics here: Luscious Garage | Blog | Gen 1 Prius Transmission Repair, P3009, P3120,...
Ok. I went outside, jacked the car up, and put it in drive. On the ground it will not move too fast before revving out and stopping. In the air,...
Ok. Any ideas what the readings should be, and the procedure to do it? I tried searching it and found very little information on the exact procedure.
I am looking at an 03 Prius that seems to have a Bad MG2 Stator. I seached and searched to find how to troubleshoot one with diagrams and...
Made the mistake of buying a car through copart. Took a front hit, which I plan on fixing. Only problem is it was shown as running, but some...
The lock cylinder is fine now with that plug removed. I found what looks like the position sensor that the lock cylinder gets a reading from,...
Ahhhhh. I'll check that out. Thanks.
Well, found out today it is the lock cylinder. Took the column covers off today, and found disconnecting one of the harness plugs has it working...
My actron is good, but shows no subcodes so it will not suit my uses on a prius. Did some searching, is this a good one for my needs:...
Well, I guess that could be causing the misfire issue then. I read in other areas of the internet it was nothing to worry about. I'll do the rag...
