Separate names with a comma.
When cells are manufactured, even within a batch run, there are variations in capacity and IR .. So each cell is individually tested, cycled and...
My Question is what do A123 recommend in there documentation for these cells?
Does this mean you do NOT have 70 cells as a MATCHED battery set from at the factory ?
Do these cells have pressure release valves? pressure can build up in LiFePO4 cells and cause them to bulge and the plates etc to separate ....
They all have "SynECO" in the comment on each line
Hope you documenting with Pics your A123 build ?? .. considering using these for my next project ... . a PHEV SUV
Also added my previous change to Main after your AHT OPEN for INPUT F9() : Log=1 ' SynECO Initiate logging and Default Logging ON F11() :...
OK, repowered Duino from OBD so AHT is kept in memory ... But AHT was still not persisted across power removal from DuinoCANview... Seems the...
Are there CANbus messages or PID that show status of PRIUS steering wheel buttons ? Or any TIPS on using the Torque Pro Command button to send...
Oky Dokies :)
First AH test : AH seems to be calculating OK BUT the Data is NOT persisting over restart of Vehicle so is going back to zero AH each time the...
Tried this yesterday and my BMS+2 does NOT drop SOC when in vehicle in EV mode AND PHEV mode... ( Will double check again today but am sure would...
.
This looks AWESOME and was our NEXT "Must Have" .... cant wait to test out and feedback .. We can use this figure to produce PHEV SOC % and/or...
We dont use EV Mode (or AUTO EV mode) and Forced EV mode together normally ... Our BMS+2 is in standalone mode and I dont believe the SOC reported...
Agree .. The UBW32 ( USB 32-Bit Whacker - PIC32MX795 Development Board - Dontronics ) is a good candidate as has the two CAN bus interface AND...
Already implemented :) with above changes mesntioned... Should soon add a new LOG file just for the DTC logging ... to ensure we know all DTC...
It will take YEARS to full up my 4G SD card :)
Made update to check for Forced EV codes : F11() If codes detected & Forced EV=1 then then F12() automagically. Combined with wireless remote ICE...
