Separate names with a comma.
There is a Rustoleum spray paint "Hammer finish gray" which is a very close match, in a shade of metallic gray, to the existing finish. If you...
Here's the answer. A center vent that won't stay where you put it, flops up or down, has a broken link. There is a 12mm x 3mm plastic link...
The bezels for the factory info display and audio are well documented by audio installers... and with those out of the way there is visibility...
Before posting here, I searched YouTube for this kind of video... searched Toyota parts sources and Googled in general for this problem. I did not...
Hello, My center AC vent is loose... it flops down, or when pushed up, stays up as if it were spring loaded in the up position. Are there any...
If the EGR was dirty it's possible that the intake manifold is also plugged up. Those are hard to clean. The dealer would probably recommend...
The dealer probably won't do a cleaning... they will replace the part according to the service bulletin. It might be necessary to replace the...
What's a good source for all these in one place, without paying $20 to ship $10 worth of screws...
This procedure worked.
I am taking out the dim blue LEDs a former owner put in, going back to top of the line Sylvania H11. More light, better pattern by far.
Hindsight perhaps but your non OEM modifications appear to have burned you.
Is the car in [D]... or ? In Brake Mode it won’t go into EV.
If the housings are oxidized, get them cleaned and polished... some Toyota dealers offer the service... and put the factory OEM or a standard like...
The two things are not comparable... oil carries contaminants and wear byproducts (metal particles) that you can remove from the engine, to...
Concerning the transmission fluid,... the Toyota spec WS oil is approved in part because it's non-conductive... and there are two electric motors...
Untraceable leak in the trunk of a Civic, plus a rear end collision, basically made the decision for me to total a car. It shouldn't be like this....
Photos below. Removed both taillights and ran a length of Gorilla tape to smooth out the irregular nooks and crannies behind the black filler...
Follow this video exactly, including the steps with the bumper cover. The taillight will not come out if the bumper cover is in place... loosening...
I'm going to glue in a piece of screen covering the gap between the taillight housing and the body, so that leaves and debris can't get behind the...
