Separate names with a comma.
I have the same P0108 MAP sensor problem on my 2010 that you posted about. I'm trying to chase the open ground problem you chased. A...
Mendel, my thanks to you for your many helpful comments to my PriusChat postings through the years. Can you suggest where I might find a pin-out...
@Bookkeeper, could you elaborate where you found the chewed open ground lead to the sensor? I have the same problem on my 2010. I get P0108 on...
Earlier this week I posted a bitchy message to this forum talking about the failure of my HID headlight electronic ballast caused by the headlight...
I'd pass on buying it. You're looking at replacement of front wheel bearings and sway bar bushings. The variable valve timing servo probably...
If your Prius HID headlight assembly is fogging with water after a rain or car wash, my advice is to replace it immediately. One of the...
I'm trying to plan the replacement of front sway bar bushings on a 2009 Prius where I will acquire tools at the jobsite and work in...
I'm traveling out-of-state to work on a woman's 2009 Prius. The task is replacing the sway bar bushings. The sway bar links were recently...
From my experience owning three high mileage Gen 2 Priuses, I'd ask questions of the vehicle's present owner about the traction battery and the...
Can anyone suggest a starting point to diagnose a 2006 Prius that flashes both tail lights rather than one whenever a turn signal is engaged? Is...
I replaced noisy front wheel bearings on my 2006 and 2009 Priuses at roughly 100k miles. Are you guys saying that the problem of short-lived...
Thanks, Mendel. I always look forward to your posts. You are correct that the culprit in standard (non-hybrid) R134a is the conductivity of the...
Georgina, thanks for replying. Can you say where this stuff is available? Since my earlier posting I've determined that A/C PRO is a division of...
Anyone know if hybrid-compatible R134a refrigerant been banned from retail sale? I can find only one online vendor selling hybrid-compatible...
Oh no, not even close. At 140k my EGR cooler was liquid-tight with carbon deposits. You couldn't even see the internal honeycomb through the...
Thanks, guys. I plead stupidity. This is one instance when my Purdue electrical engineering masters degree failed me. I should have taken my...
Has anyone attempted to test a Gen III EGR valve on the bench after cleaning it? I expended an entire can of brake cleaner (the good, non-CARB...
Frank1234, I am also in Indianapolis (west side, Eagle Creek) and interested in installing an oil catch can on a 2010. Possibly we can collaborate.
Recently purchased a used Gen III without reading this forum. Now that I am older and wiser, my advice is to skip Gen III entirely. This...
