Separate names with a comma.
They start at $1300 with a 1 yr warranty.
I don't even fool with changing the gen 1 modules. I'll retrofit the whole pack to at least 2nd gen modules. The old ones are junk.
If the body, interior, and tires are decent you probably won't go wrong for $500. You could probably recover at least most of that, maybe even...
That kinda depends on your situation. If you want to save money and have time, tools, and some research/DIY skills you could retrofit it with 2nd...
Is it feasible for you to buy a mini vci and install on an old laptop to check the codes yourself? If so, you can DIY for a lot less than taking...
Definitely take it back in. They should check the stored fault codes to see what is/was going on, and should do so at no charge to you.
These 2 covers just pull off if you grab one side and kinda spread it (pull it out and up to unsnap). Just pay attention to where each cover...
I've got 34. They were reconditioned about 2 years ago. I have since checked 8 core packs and not found a single good module. I'll need to to...
Definitely a ditto! These cars are prone to leak around the seams at the hatch and run into the car undetected, dripping behind the upholstery....
I've got some times recorded, but I'm not there to get them right now. I'll try to send them to you later.
Not everyone that rebuilds batteries does poor work or sells poor quality batteries. However, I pulled a battery out of an 05 yesterday that...
My apologies for not reading the original post thoroughly. It does sound like the HV battery is run down. For around $350 or $400 you can buy a...
That it is! I took one out last year. I honestly don't remember for sure, but I think I took it loose from the condensor and removed the...
Especially when you can buy a Toyota battery on ebay for $200 or less and spend 10 minutes putting it in.
I agree with Patrick. I recently had the brake pump replaced with a used one from my parts car and it worked great. You would save money by...
I think it's about 14 or 15 ft/lbs. I'd have to go look
I know the feeling! Good luck!
You really should think about load testing all the modules. If any drops considerably more voltage under a load, it's probably not any good....
I remember finding a burnt wiring harness in a couple of 01 models. You need to check the wiring harness that runs down the side of the battery...
Where are you located? I have one I'd sell, a Hitec x4.
