Separate names with a comma.
Anybody know how to test 2010-2015 TOYOTA PRIUS BATTERY VOLTAGE SENSOR 89892-47020 OEM B6418
Place cups of ammonia in vehicle when it's parked, also in engine compartment, then keep an eye out for dead mice though they usually just vacate
Lol...nice theory, makes some sense...it does make me wonder if thermo dynamics engineers worked on it intially. There is a strange balance to...
In the 2010 it only dumps exhaust air into trunk area above spare tire.
The only venting I see is the black soft tubing for venting potential gas discharges from each module - think that was only on for a few years....
In observing the differences in temperatures where the middle and end of the battery pack are always significantly higher then the front end where...
Any Prius DIYers in San Diego area?
Was thinking of the economy grade furnace or air conditioning filter material from Home Depot. Will be trying it out.
yep, thanks, reread the specs which state lead acid battery. Been using RC charger on the weaker, problem batteries, reconditioned 8 of them,...
Saw on e-bay a charger that is claimed to be applicable for 2013 Prius C, very cheap price, anybody have experience with this? 110V/220V...
Yep, EGR was blocked by about 1/5th with plenty of carbon. took about 15 minutes to remove, a couple hours soaking in fuel injector cleaner then...
Not sure about the amperage limits in EV mode, but my 2010 in EV mode will quit that mode as soon as there is an extra work load or too much of a...
Just doing a fast load check doesn't work. The discharge rate needs to be examined and then further tested for those modules discharging faster...
The modules I suspected by noticing there voltages fall faster are definitely on the weak side.
My 2010, gen 3 has the vent tubes, think they stopped a couple years later
Looking around found on http://www.hybrids.co.nz/ that a range of 40 to 75 minutes is an extensive test to make sure of the quality of a battery's...
Started with 7.8 volts with a 12 volt headlight load. After 23 minutes it is still at 7.05. It's taking between 2 to 3 minutes to drop another .01...
Load testing modules, how long you run a load test on a module?
Helps to be logged in.
All contacts have corrosion, some worse than others. The 3 worst corroded copper pieces also show signs of heat stress, am glad I'm taking the...
