Separate names with a comma.
Could it be easier to just see if Matt could send a complete combo meter? Do Anniversary Editions have problems with their combo meters that might...
In my experience, you can try to use a punch to unstake it, but the socket itself does a better job. It just takes a bit (a lot) more torque. Just...
Sorry valde3, I didn't notice that in your post. I can definitely confirm that the Beck/Arnley is 32mm, since I just replaced my second one today.
The original nut is 30mm, which you should be able to use a 1-3/16 socket on as well, but in my experience, the Beck/Arnley replacement nuts are...
2010-2015 cars are the third Prius generation globally. That may be the second generation available in New Zealand, but it's actually the third...
If I recall correctly, my Chilton book says it's 25 ft-lbs. I tried it and it seemed terrifyingly high. I didn't want to torque it anymore, so I...
Well, no, but combine 113 lb-ft of torque, thread lock, 240000 miles and 12 years of corrosion, and one pipe on the handle of a socket or wrench,...
Another thing I found was that my strut-to-knuckle bolts had thread lock on them. Why? There are torque specs for a reason! You don't need thread...
I don't know. That's what I'm hoping. I applied silver anti-seize compound to my entire knuckle sleeve and flange face to make it easier to get...
Be careful with using a socket too, especially if you're hammering on it. We broke a socket on my first hub by hammering it against the race.
I used a propane torch a little bit on my second hub, but I don't know if it helped. Someone on another forum said you would need an oxy-acetylene...
I've just done both my front hubs. I just hammered them out. A lot of hammering for about 20 to 30 minutes, but they came out. Now that your core...
Axle grease is right, except in my case it's tie-rod end grease. I just replaced my left front hub today, and found that, probably while I was...
I think as an integrated hub, there is no practical way to replace just the bearing. The hub itself is only $40-$100 from RockAuto or Detroit...
My car also hums around left curves. I expected the passenger side bearing to be bad, so I got a quote from my local hybrid shop for $365 for one...
I'm also in Kentucky. I assume your daughter is as well? If so, you can get an aftermarket cat legally and it will be significantly cheaper. It's...
I would say NEVER get a reconditioned battery, at least not for anything over about $4-600. If you're going for a GreenTec one, why not just find...
I guarantee you have semi-metalic. Cheap, dusting, noisy. All signs of semi-metallic pads. I don't know as I would assume there's a huge...
All gasoline engines are possible to crank without spark plugs. It actually makes it a lot easier to crank. Obviously, it's then impossible to...
Sounds fairly promising overall. On the mileage issue, if it's very cold and snowy there, I would expect fairly low mileage over just 50 miles,...
