Separate names with a comma.
I use this bluetooth device in my prius. I listen to youtube videos, i heart radio, pandora, amazon music, soundcloud etc. with my iphone [ATTACH]
My ac compressor had a short last november and caused a check hybrid system. I was able to pinpoint my problem using techstream. I bought my...
A member here had posted this in the oil catch can thread. Claims to not burn oil because he changes his oil every 5k miles. I have always...
This is exactly what I was looking for. A prius owner with high mileage doing 5k oci. You proved my point. 10k oci (oil change intervals) hurt our...
I think the gas/water breaks down the viscosity of the oil, while heavier deposits stick to the bottom. Water/gas break down the viscosity of oil...
Same here. Even with baffle, stainless steel and brass filter in place, not able to trap 100% of oil mist. The clear hose is starting to turn a...
You could have one of the vendors on thingiverse print these out. Ask for peek filament. I have been so busy with designing parts for my new...
I have full coverage insurance and would hope someone would steal my car because it is worth a lot more than I paid for it. I have not got around...
I believe it is 68mm but the file I had to bump it up 68.485~68.515 to counter shrink rate of nylon. It is snug. Any of you 3d printers would know...
Abs will sag with heat. A lot of things that appear to be plastic(abs) under the hood are blends on nylon, polyurethane, polypropylene, pvc,...
Try resetting the rear caliper with this tool to see if it is seized, can't trust to many mechanics these days. Advance Auto Parts - Down for...
It should not if you are properly torquing it down. I would use blue loctite, it will prevent corrosion and keeps bolts from backing out. [ATTACH]
It is in my signature in blue for the file link to thingiverse. If you have a 3d printer it is free to print. Pla+ did sag but worked. The nylon I...
If your 2012 prius is clean, good tires, clean windshield (no cracks pits) try 2500$. If you ask 1500$, some idiot will low ball you for 1000$ or...
Your oil catch can is connected back the intake plenum or is it open like in the pic? If it is connected like the pic, you are going to have a...
Head gasket can be done without pulling the motor but may take the same time as pulling. The timing chain cover is a pain in the a s s. I asked if...
They make direct injection spray cleaner in an aerosol can but has to be applied at the throttle body or inside intake manifold. The pruis is a...
A dirty/leaking/bad fuel injector, can create insufficient combustion, knock and even flood a combustion chamber. The carbon deposits from the egr...
If the system is factory clean, like a new prius intake manifold, the oil catch can would do nothing to prevent knock at first start up. The occ...
Seals are cheap to replace but a full refrigerant recovery is needed along with a vacuum pulled on the system for 30~45 min before refrigerant is...
