Separate names with a comma.
I've worked on these since they were cable lever operated in the late1960's. It called a "diverter door." The bower assembly on the Prius w/o...
That might be rue in areas like Souteern California, where thre may be a few Gen III Prius models in the yard. But where I 'm at, the are few and...
Sorry, I would like to post an exploded view parts diagram of the component, but that option is not allowed for me by the moderators. They are...
The 2012 to 2015 Prius"v" blue shif knob would also look good on hhe Gen II shifter. It is an easy direct fit.
It's a combination of the "mold release" compound and "outgassing" of the compounds used the materials that make up the combination meter...
It would be very difficult to make one. The lens is injection molded from acrylic (Plexiglas or Perspex) plastic. Just think like what it takes...
The engine on my 1998 Mazda MPV began leaking about 10 years, ago. It leaks half a quart in 5k miles. After trying again an again to fix the...
I had a 5 liter 1977 Camaro that the Chevrolet dealer did three front oil pan seals on. It still leaked when I traded in the car 10 years later.
Replace the "glass." It's about $40 at the dealer.
If it was the crankshaft pulley seal, I'd eplace it, is a simple job. If the cover is weepinga quarter a quart in 5k miles, an it is NOT under...
do not know. I noticed the same when I did the survey on my 2012 "v" wagon. I noticed that they emailed the survey to me as a former subscriber. I...
I'll try that the next time that I'm under the hood to check engine oil level.
Tha being so. I will be sure to do a thorough inspection with the engine cover off before the 60th month of ownership.
I would still suspect the "front seal" on the crankshaft, unless there is oil oozing from the cover gasket area.
Since the crankshaft pulley on the Gen III Prius is the same ao the one used on the Corolla, it does hae multi-v belt grooves. But, is has no belt...
Wire insulation is rated for a certain temperature. Most insulation becomes soft at around 200 degrees F. A high amperage flow of current has to...
Too expensive. I'd search elsewhere.
Having done many defect and catastrophic investigations in aircraft systems failures, I don't believe that most dealers service departments are...
Since the shift knob on the gen II has a similar mounting location, I cut down the lever on my 2012 Prius"v" and made this micro Duracon TRD knob...
You apparently did not read my post in this thread. It could be just the crankshaft seal, which is a relatively inexpensive repair. Crankshaft...
