Separate names with a comma.
I'm back from a short trip. The car acts normally, no check engine light, no odd sounds. I think, I have confirmed (with an improvised sort of...
It looks like a Toyota drawing, I think. Mat
I have to use this car in few minutes, so I will see, what happens on cold start ;) You are writing, as I had a scope... but I don't. I can...
Shouldn't it be possible for me to measure the voltage on the terminals with a plain voltmeter? It should give me about 5 or 6 volts between a...
The film is now about 10 times smaller - sorry, I didn't think about it right away ;) Here the link once again:...
Im writing from Poland. I simply give you all I have: Calibration ID - $7E0 34717200 Calibration ID - $7E0 A4701000 Calibration ID - $7E2...
I tried to link the video _with_ h t t p s : / /, but PriusChat refused to accept the whole post, if I let it stay in the link... Maybe I'm doing...
I will consider to scale down the video and reupload. And try to keep the audio untoutched. I regretely do not have a scope, so it is not an...
I think, I can give you the calibration ID - but which one? Calibration ID - $7E0 Calibration ID - $7E0 Calibration ID - $7E2 Calibration ID -...
If I click on the link, it opens a new tab in the browser and shows me the video - no need to download. I'm not planning to remove it tomorrow ;)...
I don't have a scope :( The idea with the connector is not bad - one could actually know, when the ICE is about to shut down... Mat
My ICE was cold soaked - standing in the garage over night. So starting it would demand the EGR open? It is then in the so called in Germany...
The clicks extracted: lares.nazwa.pl/Pliki/20220915_131113_clicking_sound_extracted.wav The clicks extracted, slowed down and amplified:...
*** Sorry folks! I had to split the post in a few parts, as it did not want to be posted as a whole ;) *** At some point I stood in front of my...
*** Sorry folks! I had to split the post in a few parts, as it did not want to be posted as a whole ;) *** But this was only the beginning of my...
*** Sorry folks! I had to split the post in a few parts, as it did not want to be posted as a whole ;) *** But I'm sure, it was a problem of my...
*** Sorry folks! I had to split the post in a few parts, as it did not want to be posted as a whole ;) *** OK folks, I think, I have stuff to...
I managed to undo the screws with a well sitting bit and a short ratchet. And yes, it demands a reasonable hand strength rotating _and_ pushing...
I absolutely agree, but, if you don't ask, you will get no answer for sure ;) Mat
Bump? No pressure, but it would be extremely ineresting ;) Mat
