Separate names with a comma.
Sadly, Ed might be right, if the aftermarket lower control arms are of marginal quality.
How about the front struts - have they been replaced yet?
Look on amazon.com and buy the correct NGK or Denso iridium spark plugs for your car. I would expect to pay ~$12 per plug. [MEDIA]
As Ed indicated, pin 3 should have 12VDC at ALL TIMES. A few years ago, another poster thought he would be clever by determining the current...
The barking noise may occur more at higher altitudes. I would not be concerned if that is the only issue.
Should be 220 uF.
Your next move is to check the fuse and if it is good, see if you can measure 12V at one terminal of the fuse socket.
Yes, that shows the motor winding has a short. Replace the AM2 fuse if blown.
1. When were the iridium spark plugs last changed? 2. Have you tried replacing the fuel injector for cylinder 4? 3. Have you performed a...
I suggest you disconnect the 12V battery before you charge it since the battery is in such poor condition. Then you don’t have to worry about the...
Connect the multimeter negative test lead to body ground, and the positive test lead to pin 3 of the CHS W/P relay socket. You should measure...
Maybe an engine mount is failing, which is causing the clonking sound?
Perhaps a dog took an unusual interest in the tire?
Pins 3 and 5 are the relay switched terminals and are correct. Use a paper clip to jump the terminals and see if the pump activates. If it does,...
Have a used engine installed.
1. How much fuel is in the fuel tank? 2. Check the AM2 fuse. If it is blown, replace the inverter coolant pump (located below the driver's...
The engine thermostat is rated to open at 82 degrees C (180 degrees F) so if you are seeing coolant temp of 180 degrees F that is quite normal...
Maybe the wiring harness connection to the thermos temp sensor is broken. If the fault code remains after you've tried to clear it, then there is...
1. Measure the voltage across the 12V battery. Make sure that both battery cables are tight, especially the negative cable where it bolts to the...
That part is referred to as the front suspension support subassembly in the factory repair manual. It is the upper portion of the strut assembly,...
