Separate names with a comma.
That first link I have been through in detail. Already thinking of laying it out on a board with some DIN rail and terminal blocks. I have to say...
Indeed you could, if you knew the number of links (though that is not published anywhere in the FSM, at least that I saw). My local dealer had...
I read and thought on this more last night and still can't find any way to accurately time the engine without the links. I think, ASRDogman, that...
Thanks! I will see if I can log the data with the free version so I can keep my eyes on the road. I'll pay for it if I need to thought. I was...
I put it back together with the one O-ring that wasn't trashed (didn't look great but didn't look terrible either) and buttoned it up. Will drive...
This duplicate post brought to you by PriusChat.com
Further elaboration... With the crank in its position shown, the exhaust cam mark is almost at its top dead center, and the intake cam mark is...
FWIW, apparently I had two o-rings on that one fitting between the valve cover and the intake cam phaser. One was stuck to the valve cover and...
Ok, all three of these photos were taken at the same time (without rotating the crank at all). Is my timing sure to be good based on this evidence...
Great suggestions guys. I drove it for a couple more hours today and it threw the code again about every 20-30 minutes. I got home, double checked...
I just replaced the 12v battery. It lasted 13 years and 262k miles!!! Pretty crazy. Anyways, would I need to purchase the full diagnostic test in...
Can anyone help me interpret these results? Should I pay for the full battery test? My car is a 2010 with 262k miles. But was used as a highway...
Thanks OP for following up with the resolution!
Drive it for two hours today. It drove fine the whole time, with no issues. I left the wiper cowl off so it was kind of noisy. But sounded fine to...
I put the crank timing mark at TDC and then put the painted links on the marks on the cam sprockets. But since they only get anywhere close to the...
Ok, so I think the misunderstanding is that I don't know of any marks on the engine for the cam sprockets. I was using the timing chain to...
This is what I was referring to, and what I experienced. I didn't count the full nine x2 revs to confirm, but I had to rotate quite a few times...
I don't understand, would you be able to tell by counting links? The painted links only line up on the camshaft timing marks once every 18...
I think it happened while I was putting the timing cover on. It was difficult to keep the timing chain guide out of the way when putting the FIPG...
Drove it around the block a few times and it drove great! The pending P0016 camshaft/crankshaft correlation code actually tripped the MIL, but I...
