Separate names with a comma.
Sure it isn’t a brake pad wear indicator, intermittently howling under cornering load?
Defeating safety features is a bad idea.
Yikes!
The rodent apparently preferred it not be there?
Needs another shot! And another… And…
I get that. In my experience, the desired degree of ‘tightness’ is specified via a set torque value and re-torqued to set after X hours.
What’s the point of a set torque value when additional turns are required? Like the old saw, torque until bolts strip out, then back off half a...
Is the locking clip or bracket damaged?
If the orange seal ends up between the face of the plug and bottom of the jack, it probably interferes enough to keep the connector from locking....
Those are designed as tight clearance seals and connectors. I still suspect that orange gasket placement is the issue. It may as suggested, be...
Can the orange seal be pushed in tighter to the connector so it edge seals/laterally, but doesn’t impede vertically/axially seating the connector?
From appearances, the orange seal should be down-hole, serving as an edge seal on the mating connector.
That’s a hella pipe extension weld…
The center knob is multi-function. Thermostat, fan speed, air duct routing selection.
Does air flow increase when you manually turn the round fan control knob to high? It does sound like there is a flow constriction.
Does cold airflow increase when you turn the round automatic temperature controller to its minimum low?
What are the yellow things? Brake caliper covers?
At the time, circa 2018, that was my concern. Whatever heat cycle damage may have been done would not be rectified by a firmware reflash. And...
Why would you choose not to get it done?
You're sure you fully re-plugged and re-snapped the orange HV harness connector?
