Separate names with a comma.
What is the range of your torque wrench? Torque wrenches should only be used from 20-100% of their scale. You may have been outside of your torque...
Do a compression test. Perhaps you have a slightly bent rod from the coolant ingestion. Slightly bent rod may cause the piston to not reach the...
Just remember - in CA, you will not pass smog with a catch can. The car will fail the visual inspection component of the emissions test since...
It all depends on what is being done for that number. Prices can vary significantly by region and it is not fair to call the dealer a...
I am showing 4.2 hr. Probably $800 for labor. Shops, dealer included, usually want a decent mark-up on parts. At least 50% over their cost. I...
Definitely need to have this done. If the campaign is incomplete and your inverter fails, it will not qualify for the extended warranty coverage.
Might want to crank the engine using Techstream to prime the oiling system before doing your first start.
[IMG] - Oil was in use for 8 months under a mix of city and highway driving. - Head gasket was replaced at 185K miles due to failure. The valve...
For $11K, you are going to buying a higher mileage Gen 3, period. From a mechanical standpoint, the 14-15’s have a slight advantage since most of...
Do a leak down test. Most likely, you have a failed head gasket. Symptoms and mileage are consistent with the failures reported.
Wobble Socket Extension Set, 9 Pc. That’s fair. I think I have this set.
For me it does. I just recall squeezing the socket and extension combo in there. Get the wobble extension set from HF.
3” wobble extension and a deep 12mm socket. (3/8” drive of course.)
Just fill both full. The engine reservoir will go down a bit since you did not vacuum fill the system.
Both coolant reservoirs look low.
https://techinfo.toyota.com/techInfoPortal/appmanager/t3/ti?_nfpb=true&_pageLabel=ti_home_page&contextType=external&username=string&challenge_url=h...
The other ones you mention do not dry as strong. The longer work time is not necessarily a good thing. And some of those red RTV are not oxygen...
Just run a normal bead and add extra where the cover meets the joints.
There’s a torque sequence for the cam housing. There’s also an area under the Headgasket that is supposed to have rtv, but many people seem to...
Valve grind kit does not include the o-rings in the timing cover area iirc. You should replace the water pump and thermostat.
