Separate names with a comma.
Found the culprit to the clunking noise. It was in the top mount area. I had not tighten the top strut pin bolt enough on the drivers side....
Good question, the front fender heights are different by the same amount as the old springs. but now they are just both a bit higher by a little...
Update - I successfully replaced both front strut assemblies. Cleaned up the cowl and black plastic wiper cover area and it looks nice and new....
Okay good suggestions - I will get another spring. I filled both tires to the same psi and was wondering if maybe it might be due to uneven...
I bought ONE new coil because I noticed that driver front side seem to dip lower than the passenger front side. See pictures below: This is...
I have compiled my parts, please see pictures below - am I missing anything? [ATTACH] group shot of components for the front driver (left) strut...
Yes, okay I can see how that would feel safer as I had to drive up on wood boards to get the car high enough for me to get the 3 ton jack into...
Thanks 'exstudent' yes, that video is what gave me the courage to take on this task, it looks pretty straight forward. I think I have been more...
Okay, thanks so much Patrick for your response that makes sense. I posted some photos on the link below of the jacking point on the front, can...
Thanks for replies guys, I jacked up the car today and saw that the front dust boots are torn on both sides so I will go pick those parts up at...
Is this the right place to jack for the front of a 2007 Prius? [ATTACH] [ATTACH] [ATTACH]
[IMG] Is this the right location for jacking the front of my 2007 Prius can't seem to upload the picture
Hmmm.. okay, I was wondering about aftermarket replacements for the dust boot parts, since I am using Monroe OE Spectrum replacement struts. I...
Thanks Patrick any suggestions on good places to order that? I think I have seen that referred to as the dust boot or something like that?
