Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Those two points you are referring to are not bolted. They are more like locator studs. Once you get all the bolts out, slide fender forward till...
Slides on from the front. Toughest part is getting the little c clips to catch the studs that are near the small triangle glass. You will need...
Several different pumps. This has been going on for awhile.
My 2010 is doing this now. Takes about 15 minutes to get 8 gal of gas in. Is definitely worse when the temp drops below freezing. Anyone gather...
Pay special attention to the sliders, the grease will dissipate, creating rapid wear of the pads.
Do not need to remove the glass. The fender runs up on two studs in that area near the window. After removing all the bolts, fender comes off by...
My 2010 has blown 6 or 7 in 94K miles, I assumed it was bad design and higher than usual vibration that was doing it (I use it a lot for...
I have not had any recall info sent to me (unless I missed it) so no recalls have been performed. The stealership told me yesterday that there...
As I was entering my driveway the other night, as soon as the RF tire went from the road surface to the dirt of my driveway, the car surged a...
No coverage except from my insurance, if it comes to that. Dealer said that he was contacting Toyota on my behalf, and it looked to him that a...
Took delivery of my 2010 3 weeks ago. Took the car to Virginia and while there tried the AC for the first time (car had about 500 miles on it at...
Bought my 2010 last week, long story - short version: 3 weeks ago test drove the 4 used Prii at my local dealer, could not make up my mind so they...
Oh yeah, the papers need to be folded, bagged, banded, whatever the need when you get to the delivery destination. That is about 300 papers in...
