Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Did you figure this out?
The diagram is wrong. Feel the hoses.
Apologize for the delay . You have me stumped. There is a sensor on the thermo tank.
Thank you Yes the pump is back there. The main power plug has to come off. Then it is matter of knowing the order to remove hoses bolts and plugs....
I recently had the same issue. I replaced the heater pump. I pray the inside of the thermos is not filled with that foam. Did your pump clog...
I fixed the heat. https://priuschat.com/threads/gen-2-no-heat-flush-heater-core.213272/#post-2991730 Read it through. This may not be your issue.
The heat works. I replaced the heater (auxiliary) pump. Yes, this has been quite a journey. I started by flushing the heater core, replaced the...
I am going to test power at the control valve. I will keep you updated.
I have not tried that yet.
What failed attempt are you writing about?
Still working on it.
Thanks for the replies. Heat was full on and car was running. Flushed at the core input out put. I bled using the cock on the upper right side of...
I flushed the heater core. Elevated the front of the car let it warm and opened the vent on the right side of the radiator to let air out. Still...
Good Day I have a 2008 Prius with no heat. I have looked at the diagram above and I believe it is wrong. When I feel the hoses to the heater...
I have a 2008 gen 2. with no heat. No codes displayed. Engine temperature is normal. Bled the coolant using the bleeding valve. Actuator is...
