1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Recent Content by Kruz

  1. Kruz
    Post

    Plug-In Supply DIY

    Could be. It is in the rear cargo area, driver side rear corner. You remove the small platform to access it.
    Post by: Kruz, Jun 4, 2012 in forum: Prius PHEV Plug-In Modifications
  2. Kruz
    Post

    Plug-In Supply DIY

    Yes, it sounds like this is all you really need. Make sure it is at least 14 gauge and maybe 6 feet long so you have enough tso work with. The...
    Post by: Kruz, Jun 2, 2012 in forum: Prius PHEV Plug-In Modifications
  3. Kruz
    Post

    Plug-In Supply DIY

    1.) The power cord for the charger runs from the charger underneath the driver seat and plugs into the extension cord outlet that sits in the rear...
    Post by: Kruz, Jun 1, 2012 in forum: Prius PHEV Plug-In Modifications
  4. Kruz
    Post

    Plug-In Supply DIY

    You route them through the door channel. The Trim covers them. I had to slide my seat way up to take the picture. Normally, you can't even see the...
    Post by: Kruz, May 26, 2012 in forum: Prius PHEV Plug-In Modifications
  5. Kruz
    Post

    Plug-In Supply DIY

    Re: Happy Plug-in Supply Customer Yes, the unit does get quite hot. That is why I use a fan blow through the vertical fins to help dissipate...
    Post by: Kruz, May 25, 2012 in forum: Prius PHEV Plug-In Modifications
  6. Kruz
    Post

    Plug-In Supply DIY

    Re: Happy Plug-in Supply Customer yes, I drilled two holes in the front support brace. I have included a picture as I was half way through the...
    Post by: Kruz, May 24, 2012 in forum: Prius PHEV Plug-In Modifications
  7. Kruz
    Post

    Plug-In Supply DIY

    Re: Happy Plug-in Supply Customer I stand corrected. I guess I need to call Robb... I included a couple pictures of my front board (in its...
    Post by: Kruz, May 23, 2012 in forum: Prius PHEV Plug-In Modifications
  8. Kruz
    Post

    Plug-In Supply DIY

    Re: Happy Plug-in Supply Customer The Elcon will really only fit one way where the fins are vertical, the charge light is visible, and the seat...
    Post by: Kruz, May 23, 2012 in forum: Prius PHEV Plug-In Modifications
  9. Kruz
    Post

    Plug-In Supply DIY

    Re: Happy Plug-in Supply Customer Yes, I have this I am pretty sure. I called it the "front controller" in my previous post. My assumption is...
    Post by: Kruz, May 23, 2012 in forum: Prius PHEV Plug-In Modifications
  10. Kruz
    Post

    Plug-In Supply DIY

    Re: Happy Plug-in Supply Customer Yes, I am still on the same tank. I have traveled about 500 miles so far. However, I won't be on the same...
    Post by: Kruz, May 22, 2012 in forum: Prius PHEV Plug-In Modifications
  11. Kruz
    Post

    Plug-In Supply DIY

    Re: Happy Plug-in Supply Customer Keep in mind I am still learning about this system but it looks to be evolved from earlier versions to be...
    Post by: Kruz, May 16, 2012 in forum: Prius PHEV Plug-In Modifications
  12. Kruz
    Post

    Should I Upgrade Suspension when going PHEV?

    I didn't have any spring compression tools when I upgraded my suspension. I jacked one side up, put it on a jack stand and then used the floor...
    Post by: Kruz, May 14, 2012 in forum: Prius PHEV Plug-In Modifications
  13. Kruz
    Post

    Plug-In Supply DIY

    Re: Happy Plug-in Supply Customer Sure, I have attached a few various shots.
    Post by: Kruz, May 14, 2012 in forum: Prius PHEV Plug-In Modifications
  14. Kruz
    Post

    Plug-In Supply DIY

    Happy Plug-in Supply Customer I am new to this forum. I came here for the purposes of researching the best DIY PHEV solution for the Prius. For...
    Post by: Kruz, May 13, 2012 in forum: Prius PHEV Plug-In Modifications