Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
can probably the bolt with a lighter but how do you fit a breaker bar or impacter into the wheel well?
Finally had a chance to get to this and found the brake caliper bolt (17mm) are impossible to loosen? Want to confirm that since the bolt is...
Haven't done a coolant drain before in any car, much less a Prius. Are these the correct locations? Thought I take some pics, so no one else has,...
Actually I guess it turned out to be the cheap chinese connectors. Purchased some connectors at the auto parts store and they fit fine. Just need...
this thread used to be stickied. any reason it was removed?
I purchased two different sets and could not get the 3 prong connector to fit into the bulb connectors. the black one here sorta fits, but i have...
Anyone try this before? Just pushing the wires out of the replacement connector, do the same on the old one and just insert into the new one...
Thanks what does the other end for look like for those? I found these (see attached) with tabs. I guess you just loop the wire from the otherwise...
After removing the left headlight assembly and disconnected what appears to be the low beam, noticed the plastic connector is melted / burned. The...
Ok I see what you mean, I can you can also measure how much is drained out and subtract that from the capacity to determine the ratio you should...
Yeah it's not running, there's no sound, I read somewhere if you put your hand on it you should feel a little vibration also. I'll try to go...
Ok, for flushing I thought you could just use distilled water and run it for a short time and then repeat? After a few times, then refill with...
kk, i guess the deletion is more for security then capacity.
