Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Thanks for your comments. I will have another look.
Does anyone know how to adjust the nozzles for the screen washer jets? I normally use a pin and move them around, but have not seen the type used...
Thanks for your interest. The post was nothing to do with fuel economy and I was just passing on some info. about replacing brake pads. It was...
The post is about changing from a Gen II to Gen III. Only driving it for about a month. The brakes were in very poor condition, as mentioned in...
After nearly 10 years driving the Gen ll Prius, I must say that I am not coping too well having changed it for the Gen III - often press the...
On reading again, I see that you are asking about the parking brake when trying the "Not using Techstream method". Sorry, and I cannot remember,...
I had the parking brake on when I did the front pads, but of course it needs to be off for the rear. There was a build up of rust under all the...
I could not find anything where the recent problems I experienced fitting new brake pads has been mentioned before, so I hope this helps someone...
When I last had an LPG car, the tank was doughnut shaped and put in the spare wheel position. Worked well.
Pressing INFO shows the 'Information menu' as before. It is easy to read. I have also managed to see the 'Energy monitor' in poor light, but...
The screen is black. If I press say, 'Climate' the normal screen is shown. It then stays on that screen and does not revert to the Energy monitor...
I get the correct screen which is easy to view - do not have 'Map'.
