1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Scanguage reset and codes

Discussion in 'Gen 2 Prius Technical Discussion' started by AF1PRIUS, Oct 30, 2008.

  1. AF1PRIUS

    AF1PRIUS New Member

    Joined:
    Apr 23, 2008
    35
    0
    0
    Location:
    Southern, MD
    Vehicle:
    2011 Prius
    Model:
    Three
    This morning after filling up my car and then looking at the scanguage's fuel tank data, I decided to reset it and start over. When I did, all **** broke loose:eek:. I got a check engine light and a red triangle. Also the following two codes can up: U0100 and P0000.

    I tried to see what they stood for, but no luck. The scanguage did reset. Not knowing what I should do next, I decided to clear the codes and see if that turned off all the warning lights and it did. The car started and appears normal again. Will not really know until I leave work for home.

    Any thoughts?

    AF1PRIUS
     
    #1 AF1PRIUS, Oct 30, 2008
  2. archae86

    archae86 Member

    Joined:
    Jun 19, 2008
    153
    24
    0
    Location:
    Albuquerque, NM
    Vehicle:
    2006 Prius
    Sure sounds like the Scangauge put something on the CAN bus that the car did not like. I've sometimes wondered how much of a hazard of that sort of thing there might be--especially if one has XGauges for another model of car loaded.

    Which exact reset did you issue?
     
    #2 archae86, Oct 30, 2008
  3. AF1PRIUS

    AF1PRIUS New Member

    Joined:
    Apr 23, 2008
    35
    0
    0
    Location:
    Southern, MD
    Vehicle:
    2011 Prius
    Model:
    Three
    After I scanned for the codes, I just cleared them and all warning lights went out. I started the car (turn the power on) and the engine started and no more warning lights lights came back on so, I am hoping that when I drive home after work, all will be well.
     
    #3 AF1PRIUS, Oct 30, 2008
(You must log in or sign up to post here.)