1. Attachments are working again! Check out this thread for more details and to report any other bugs.

scan guage error codes

Discussion in 'Gen 1 Prius Plug-in 2012-2015' started by rmacguy1949, Oct 23, 2016.

  1. rmacguy1949

    rmacguy1949 Junior Member

    Joined:
    Sep 14, 2009
    8
    1
    0
    Location:
    arizona
    Vehicle:
    2008 Prius
    Model:
    N/A
    can the scan guage II read toyota error codes? how?
     
    #1 rmacguy1949, Oct 23, 2016
  2. Pluggo

    Pluggo Senior Member

    Joined:
    May 23, 2016
    608
    532
    0
    Location:
    Folsom, Pennsylvania
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Advanced
    Unless there is something very particular about Toyota diagnostic codes, I would expect that you just plug into the OBD II connector, press Menu, then Scan. You should see any stored codes. Then, if you want to, you can clear the codes.
     
    #2 Pluggo, Oct 23, 2016
  3. jdcollins5

    jdcollins5 Senior Member

    Joined:
    Aug 30, 2009
    5,131
    1,340
    0
    Location:
    Wilmington, NC
    Vehicle:
    2010 Prius
    Model:
    III
    ScanGauge will only read standard engine and emission codes generated by the Check Engine Light. It can be programmed to read Prius specific HV Battery DTC's but it is pretty complicated.
     
    #3 jdcollins5, Oct 23, 2016
(You must log in or sign up to post here.)