Resistor value for seat air bag??

Since it's probably a nichrome-wire igniter for the squib,
probably fairly low -- but like the manuals say, you should
probably NOT go testing it with an ohmmeter since that's got
some possibility of making it go off. What you might do instead
is when you got to change out your seats, or even beforehand
just to debug it in advance, is tap the squib wires at one of the
connectors [on the ECU side, not the airbag side], disconnect
from the airbag itself, and play with resistances between, at a
total guess, 1 and 10 ohms and see when the airbag controller
stops complaining about a bad squib.
.
In googling around I found this excerpt from US patent 6597181:
.
_ ... A normal resistance for a squib
_ element is typically about 2 ohms. A resistance measurement greater
_ than about 4 ohms or less than about 1 ohm usually indicates a fault
_ in the squib element. Ignition of a typical squib element requires
_ about 1 amp of current in an ignition pulse. Resistance testing is
_ typically performed using about 50 milliamps passing through the
_ squib element.
.
It may be different for the Prius. Try to find the middle value in
between the endpoints of when the car issues the warning. Remember
that it takes up to four reboots to clear errors in the car, so you
should start each test from an errors-cleared state. Be careful,
don't blow your face off, or if you do then make sure someone
captures a high-quality mpeg of the event, etc etc.
.
Then report back here, so it goes into the general pool of
knowledge!
.
_H*

 

Yes. This would be guaranteed to be most popular on YouTube. :evil:

 

2.2 ohm works for everything I've tried.

 

What kind of seats are you installing? Pics?

 

Excellent! I need to do the same thing to install my Recaro (full responsibility my own).

The seat airbag connector is the simple yellow two-wire type, it seems? Resistor across the two wires, subbing for the squib?

Thanks