1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Replaced 12V, but still have Red Triangle Light

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by bcphotography, Aug 14, 2011.

  1. bcphotography

    bcphotography New Member

    Joined:
    Aug 14, 2011
    6
    0
    0
    Location:
    Fresno
    Vehicle:
    2008 Prius
    Model:
    I
    The 12V battery went out on my 2008 Prius so I replaced it, however, when I turn the car on the red triangle, abs, check engine, traction and parking break lights appeared along with an error message on the display screen that something is wrong with the hybrid system. The READY light does not appear. All other electrical mechanisms work on the car; windows, ac, radio, ect. My problem is that the car will not engage into drive or reverse, only neutral and park. I tried disconnecting the ground wire on the 12V battery to reset the system and that did not work. I also tried unplugging and plugging in the orange fuse on the hybrid battery and that did not work either.

    Any suggestions?

    Could it be a fuse? Something with the break system?

    Before the battery completely died, out of the blue when I turned the car on the other morning, an error message popped up and said that the car was parked on an incline and needed to be parked on a flat surface (which it already was and always is) and wouldn't engage into drive or reverse either. Then the 12V lost all power. I have owned the car for a little over 5 months now and have had zero issues up to this point.

    Please help! I do not want to have to tow it to the dealership.
    Thank You.
     
    #1 bcphotography, Aug 14, 2011
  2. seilerts

    seilerts Battery Curmudgeon

    Joined:
    Mar 7, 2010
    3,326
    1,513
    38
    Location:
    Santa Fe, NM
    Vehicle:
    2005 Prius
    Do you know anyone that has a code reader? It is really hard to know what is going on otherwise. The brake/abs lights come on whenever there is a problem with the hybrid system. The initial symptom, the transaxle error message, is consistent with a bad battery. The replacement should have fixed the problem, though.

    Please double-check the HV battery fuse, as shown in the photo below. When re-inserted, the handle swings up, then must be pushed down and locked into place to complete the circuit.

    [​IMG]
     
    #2 seilerts, Aug 14, 2011
    1 person likes this.
  3. andyprius

    andyprius Senior Member

    Joined:
    Feb 21, 2005
    2,212
    188
    0
    Location:
    Sacramento, California.
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    It does sound like the HV Safety switch was not connected right.
     
    #3 andyprius, Aug 14, 2011
    1 person likes this.
  4. The Critic

    The Critic Resident Critic

    Joined:
    Oct 28, 2005
    3,193
    2,323
    0
    Location:
    CA
    Vehicle:
    2011 Prius
    Model:
    Three
    I assume you have tried powering it on and off several times? This happened to me when I replaced the 12v on a 2006. The first time I powered it on, this happened. So I powered the car off, waited a few seconds, and tried again-- and all warning lights were gone.

    I would go back and double check all connections.
     
    #4 The Critic, Aug 14, 2011
  5. uart

    uart Senior Member

    Joined:
    Sep 7, 2009
    4,215
    1,202
    0
    Location:
    Australia
    Vehicle:
    2005 Prius
    Hi bcphotography. Is there any possibility at any time during the installation that the new battery ever got connected backwards, even with the terminals just lightly touching for a second?
     
    #5 uart, Aug 14, 2011
  6. Rokeby

    Rokeby Member

    Joined:
    Jan 21, 2008
    3,033
    708
    75
    Location:
    Ballamer, Merlin
    Vehicle:
    2008 Prius
    The negative 12V wire is sometimes subject to corrosion where
    it is screwed to the body.

    Also, new 12V batteries sometimes arrive not fully charged.

    Have you considered jumping the car from under the hood?
    (Being always mindful of the correct polarity of course. ;) )
    If that works, the new battery or its connections would be suspect.
     
    #6 Rokeby, Aug 14, 2011
  7. bcphotography

    bcphotography New Member

    Joined:
    Aug 14, 2011
    6
    0
    0
    Location:
    Fresno
    Vehicle:
    2008 Prius
    Model:
    I
    Problem solved! The orange HV Safety Switch was not properly inserted the first couple of times I tried resetting everything.

    Thanks for all the quick responses from everyone.
     
    #7 bcphotography, Aug 14, 2011
(You must log in or sign up to post here.)