1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Random single beep when driving 2012

Discussion in 'Prius v Main Forum' started by RayRob, May 17, 2021.

  1. RayRob

    RayRob Junior Member

    Joined:
    Jul 27, 2014
    5
    1
    0
    Location:
    Cartersville GA
    Vehicle:
    2012 Prius
    Model:
    N/A
    My 2012 increasingly frequently makes a single beep when driving, typically when turning and occasionally when braking, but I can see no other pattern. No warning lights or messages. Just a single beep. I did try searching the forums, but most "beep" posts relate to multiple beeps, including when in reverse. This is just a single, random (but increasingly frequent) beer. TIA
     
  2. gromittoo

    gromittoo Active Member

    Joined:
    Mar 9, 2017
    719
    287
    0
    Location:
    philadelphia
    Vehicle:
    2013 Prius v wagon
    Model:
    Two
    I can't help to point out that you have a problem with an "increasingly frequent beer". Perhaps if you keep drinking that beer, you won't be bothered by the beep any longer :)

    Seriously, I am as stumped as you are. I see some posts that mention a beep if the hatch isn't closed properly. That could cause an intermittent. beep if the hatch isn't just right.. My 2013 has issues with the hatch not closing correctly, when my Uber passengers don't close it hard enough. I don't recall any beeps, just a light on the dash.
     
  3. Air_Boss

    Air_Boss Senior Member

    Joined:
    Jun 2, 2012
    4,036
    1,110
    0
    Location:
    New Yawk
    Vehicle:
    2012 Prius v wagon
    Model:
    Five
    Just a guess... A loose or failing door-open plunger switch might open (or close) when the body flexes under load (turning, stopping, accelerating).
     
  4. sam spade 2

    sam spade 2 Senior Member

    Joined:
    Mar 31, 2018
    7,035
    2,790
    0
    Location:
    USA
    Vehicle:
    2017 Prius c
    Model:
    Four
    My guess: A wheel speed sensor going bad or developing a loose connection.......triggering an ABS "alarm"......but the associated light doesn't stay on long enough to see.

    I wonder if reading the fault codes will show something stored ?
     
    djasonw and Tim Jones like this.