1. Attachments are working again! Check out this thread for more details and to report any other bugs.

OEM Switches, left side of dash

Discussion in 'Prius v Accessories and Modifications' started by Paul Anderegg, Feb 7, 2017.

  1. Paul Anderegg

    Paul Anderegg Junior Member

    Joined:
    Jul 24, 2013
    38
    7
    0
    Location:
    San Diego, California
    Vehicle:
    2013 Prius v wagon
    Model:
    Five
    I am installing a strobe warning light kit in a 2017 Prius v Two(lowercase v for the Prius v wagon because only 2010 Prius used uppercase Roman numerals for model designation and two not II for your model because of the aforementioned) I want to utilize the unused switch locations on the left side of the dash for an on/off/selector switch. Does anyone know what OEM switches go there on the higher than Two not II level Prius v (lowercase v for the Prius v wagon because only 2010 Prius used uppercase Roman numerals for model designation). I would like to use OEM switches that fit the blanking panel holes, these would be for simple on/off switching, preferably lighted dot? Recommendations appreciated! :)

    Paul
     
    #1 Paul Anderegg, Feb 7, 2017
  2. mikefocke

    mikefocke Prius v Three 2012, Avalon 2011

    Joined:
    Nov 3, 2012
    3,760
    1,679
    0
    Location:
    Sanford, NC
    Vehicle:
    Other Hybrid
    Model:
    Limited
    In a kit that included Daylight Running Lights that had a Toyota part number there was an on/off press to change state switch installed by the dealer into my car ('12 v Three). It has a small green light that lights up when the DRLs are on. I'd think that would work for what you describe and it looks completely stock. I looked to see if I had documentation, couldn't find it.
     
    #2 mikefocke, Feb 7, 2017
  3. Paul Anderegg

    Paul Anderegg Junior Member

    Joined:
    Jul 24, 2013
    38
    7
    0
    Location:
    San Diego, California
    Vehicle:
    2013 Prius v wagon
    Model:
    Five
    That sounds exactly like what I am looking for! :-D

    Do you remember if the kit had a wiring harness that attached to the back of the switch? I may just end up buying the same kit and using the harness to wire into it.

    Paul
     
    #3 Paul Anderegg, Feb 7, 2017
  4. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    24,904
    16,213
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    If it takes the same roughly 32 x 22 mm push switches as a Gen 3 liftback, there are a bunch of choices from Air On Board. They aren't OEM, but they fit, and you have a bunch of choices of what is engraved on them. (What doesn't seem offered is an unengraved front so you can engrave custom markings yourself, but maybe they'd sell that if asked.)

    -Chap
     
    #4 ChapmanF, Feb 7, 2017
  5. Air_Boss

    Air_Boss Senior Member

    Joined:
    Jun 2, 2012
    4,036
    1,110
    0
    Location:
    New Yawk
    Vehicle:
    2012 Prius v wagon
    Model:
    Five
    #5 Air_Boss, Feb 8, 2017
  6. Paul Anderegg

    Paul Anderegg Junior Member

    Joined:
    Jul 24, 2013
    38
    7
    0
    Location:
    San Diego, California
    Vehicle:
    2013 Prius v wagon
    Model:
    Five
    #6 Paul Anderegg, Feb 8, 2017
    Air_Boss likes this.
  7. Paul Anderegg

    Paul Anderegg Junior Member

    Joined:
    Jul 24, 2013
    38
    7
    0
    Location:
    San Diego, California
    Vehicle:
    2013 Prius v wagon
    Model:
    Five
    #7 Paul Anderegg, Feb 8, 2017
  8. xliderider

    xliderider Senior Member

    Joined:
    Apr 19, 2012
    7,919
    3,142
    0
    Location:
    Honolulu, HI
    Vehicle:
    2011 Prius
    Model:
    Three
    #8 xliderider, Feb 8, 2017
  9. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    24,904
    16,213
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    The link I supplied above is to a southern California outfit; mine didn't take long to ship at all.

    -Chap
     
    #9 ChapmanF, Feb 8, 2017
(You must log in or sign up to post here.)