1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Missing Rubber Caps

Discussion in 'Prius v Care, Maintenance and Troubleshooting' started by ahmad ashfaq, Mar 22, 2015.

  1. ahmad ashfaq

    ahmad ashfaq Junior Member

    Joined:
    Oct 30, 2014
    57
    8
    0
    Location:
    islamabad islamabad
    Vehicle:
    2011 Prius Alpha
    Model:
    N/A
    Dear Folks,
    I found these two rubber caps(2 pieces) missing under the chasis during an oil change in the center of Prius alpha, the carpet is visible
    Can some one describe it to me what are these for?

    regards
     

    Attached Files:

    #1 ahmad ashfaq, Mar 22, 2015
    Last edited: Mar 22, 2015
  2. My590L

    My590L Junior Member

    Joined:
    Aug 27, 2014
    42
    8
    0
    Location:
    NorCal, CA
    Vehicle:
    2014 Prius
    Model:
    Five
    If that is a photo taken from under your car, that means they did not install the proper rubber grommets from inside the vehicle during assembly in the Trim area prior to installing your carpet. These holes are necessary during the painting process to allow the ED phosphate to drain when they prep the vehicle bodies for receiving the paint as they enter and exit large tanks. Depending upon where the two rubber caps are missing, it may be fairly easy for you to install yourself. I would show it to the dealer and tell them it was a manufacturing defect that these were not installed.

    Good luck. Let us know how it works out.
     
    #2 My590L, Mar 22, 2015
    ahmad ashfaq likes this.
  3. ahmad ashfaq

    ahmad ashfaq Junior Member

    Joined:
    Oct 30, 2014
    57
    8
    0
    Location:
    islamabad islamabad
    Vehicle:
    2011 Prius Alpha
    Model:
    N/A
    Dear My,
    Thanks for the reply ,
    If i wanna to install my self , do i have to detach the negative terminal of the battery to prevent airbag from opening or i just remove the seat to remove the carpet before installing them .
    regards
     
    #3 ahmad ashfaq, Mar 22, 2015
  4. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    24,906
    16,213
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    If you obtain the right rubber plugs, you might be able to fold and squeeze them into position from below the car without disturbing the carpet at all. It won't be totally easy because the tops are the wide parts, but they are somewhat flexible and if you can do it, and make sure the bottom lip is even all the way around, you'll be done in 5 minutes.

    -Chap
     
    #4 ChapmanF, Mar 22, 2015
    ahmad ashfaq likes this.
  5. rdgrimes

    rdgrimes Senior Member

    Joined:
    Jun 7, 2013
    1,740
    446
    4
    Location:
    New Mexico, USA
    Vehicle:
    2018 Prius Prime
    Model:
    N/A
    I'm not so sure they wouldn't stay put even if you put them in upside down from the bottom. In any case there are a number of available options for hole-plugs, a internet search should reveal quite a few.
     
    #5 rdgrimes, Mar 22, 2015
    ahmad ashfaq likes this.
  6. Mike500

    Mike500 Senior Member

    Joined:
    Mar 1, 2012
    2,593
    764
    0
    Vehicle:
    2012 Prius v wagon
    Model:
    Two
    The cap plugs are installed from the bottom; NOT from the top under the carpet. So, there is no need to disconnect the battery. Although that won't hurt anything.
     
    #6 Mike500, Mar 22, 2015
    ahmad ashfaq likes this.
  7. My590L

    My590L Junior Member

    Joined:
    Aug 27, 2014
    42
    8
    0
    Location:
    NorCal, CA
    Vehicle:
    2014 Prius
    Model:
    Five
    I am not sure if you have to detach the negative terminal or not. If you have to unplug the wire harness from the seat, it might be a good idea. Perhaps someone else on here can fill you in.
     
    #7 My590L, Mar 22, 2015
    ahmad ashfaq likes this.
  8. RRxing

    RRxing Senior Member

    Joined:
    Jul 7, 2009
    2,522
    1,795
    0
    Location:
    NEPA
    Vehicle:
    Other Hybrid
    Model:
    Limited
    The plugs are installed from underneath the vehicle
     
    #8 RRxing, Mar 22, 2015
    ahmad ashfaq and Mike500 like this.
  9. Mike500

    Mike500 Senior Member

    Joined:
    Mar 1, 2012
    2,593
    764
    0
    Vehicle:
    2012 Prius v wagon
    Model:
    Two
    The fact that there is an indented flange around the hole recessed upward into the metal explains it. That's to allow for the larger outer flange of the plug.
     
    #9 Mike500, Mar 22, 2015
    ahmad ashfaq likes this.
  10. ahmad ashfaq

    ahmad ashfaq Junior Member

    Joined:
    Oct 30, 2014
    57
    8
    0
    Location:
    islamabad islamabad
    Vehicle:
    2011 Prius Alpha
    Model:
    N/A
    Thank you folks , ill try from the bottom up first , you made it easy for me .
     
    #10 ahmad ashfaq, Mar 23, 2015
  11. jzchen

    jzchen Newbie!

    Joined:
    Apr 9, 2012
    3,311
    1,017
    0
    Location:
    Arcadia, CA
    Vehicle:
    2012 Prius v wagon
    Model:
    Five
    Side airbags are in the seat right? If true, definitely disconnect ground first!

    MT2L03 ?
     
    #11 jzchen, Apr 18, 2015
    ahmad ashfaq likes this.
  12. mikefocke

    mikefocke Prius v Three 2012, Avalon 2011

    Joined:
    Nov 3, 2012
    3,760
    1,680
    0
    Location:
    Sanford, NC
    Vehicle:
    Other Hybrid
    Model:
    Limited
    Always disconnect the 12v battery any time you are messing with anything that involves an airbag. If one of those should inflate with your head near it .....
     
    #12 mikefocke, Apr 19, 2015
    ahmad ashfaq likes this.
(You must log in or sign up to post here.)