1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Loose support hold (handhold)

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by rubin110, Dec 3, 2018.

  1. rubin110

    rubin110 New Member

    Joined:
    Dec 3, 2018
    6
    3
    0
    Location:
    San Francisco
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    Hi there. New to the forum, and fresh Prius owner. My partner and I bought a 2012 Prius Plug-In last month and have been absolutely happy with it. We've already done a couple of upgrades on it.

    The other day I finally cornered a rattle sound down to the front passenger side support hold (handhold, the thing you grab onto when the driver is driving and turning too sharp). I took the cap off (and sadly think I partially broke it), but couldn't figure out how to go about tightening it all back down so the whole thing doesn't jiggle around anymore.

    After some amount of Googling I had a hard time locating anything that would help me with this specific car. Does anyone have any advice on how to tackle this?

    Thanks!
     
    #1 rubin110, Dec 3, 2018
  2. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    110,156
    50,059
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    congrats and welcome!

    sadly, i have never had to deal with this, if no one else has advice, you should be able to find what you need in the service or body manual at tech info.toyota.com

    all the best!(y)
     
    #2 bisco, Dec 3, 2018
  3. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    24,912
    16,215
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    If I remember right, those are held in place by spring clips, nothing threaded that you could 'tighten'. It's possible one or both of the clips isn't pushed in all the way, so you could try doing that. Or maybe one was damaged, either by an incorrect removal attempt, or a whole lot of force really being applied to the handhold. That might mean, in the worst case, getting replacement spring clips. You'd just squeeze the existing ones to remove them (after pulling out the recalcitrant decorative cover, as you did already), and pop the new ones in.

    If you look up the PDF instructions for the side-curtain airbag recall, it has good instructions on how those mounting clips are dealt with, IIRC.

    -Chap
     
    #3 ChapmanF, Dec 4, 2018
(You must log in or sign up to post here.)