LED blinkers give fast blinker error

You'd need to install a relay to correct for the fast blinking.

The Valenti turn signal LEDs already have a high power resistor in parallel to prevent hyperflashing so they'll work right out of the box. No external relay/turn signal LED canceler box needed like some of the aftermarket lights such as Crystal Eye.

 

$330 for full LED? You must've bookmarked the cheaper Spec-D Tuning taillights, which don't look quite as nice as Valenti. The Valenti lights are on sale for $420 shipped until May 25th. $90 is worth it for the much better looking Valenti lamps and they have more LEDs/better light outputs compared to Spec-D Tuning.

 

And, in the 2010 Prius the turn signal relay is in the top of the dash on the driver's side. If you want to change it, the Toyota repair manual starts with taking the top of the dash off.

I've seen others claim that the relay is just above the brake pedal. Not in this case.

 

I assume this applies to the front turn signals also. I too went to install some LED bulbs in the front turn signals but got the fast blinking. Where is the relay for the front signals and where do I get the relay? The bulbs I got were superbrightleds 7440-A15. What LED bulbs for the front turn signal work out of the box?

 

I just got my LED relay from iJDMToy and will probably install this weekend.

^ the relay controls both the front and rear turn signals.

I saw a picture of the relay and it was just above the brake pedal. Guess I will find out this weekend...

 

I've Been looking for a video on how the Grazio-co Tail lights look. Has anyone seen a video on them?

 

http://priuschat.com/forums/gen-iii...ations/86583-drl-bulb-technical-question.html has all the information on what flasher to get and how to replace the flasher to LED flasher.

 

Haven't seen a video of it, but why would anybody be interested in spending $1000+ for essentially the same look that you can get with a $50 vinyl overlay on the stock taillights? Get the Valenti if you want a truly unique look.

Grazio tails below:
[/QUOTE]

 

I guess I'm going to try these from ijdmtoy. I hope hey fit.
7440 Error Free LED Bulbs | Turn Signal Lights, Backup Lights

 

Please let us know how they work. A video with them in operation would be nice as well.

 

Just put those in this weekend. They have wires to resistors that require them (the wires) to run along side the bulb through the fixture hole. The clearance in the rear light fixtures was so little that the wires were severed when I locked the bulb into place. See this other thread.

They sent me up the non-load flasher relay so I was able to just cut those wires off the bulbs and run without the resistors. All is working great now.