Is there a link for vent removal.

left side or right side of the MFD?

 

Took me over an hour to get the driver side vent off to adjust my brake light switch. Couldn't find any proper instructions out there. They all go into huge detail for the subsequent steps, but totally gloss over how to get that first piece off. After I'd done that, everything else was pretty obvious.

The outermost vents are secured by 3 pairs of clips - 2 at the top edge, 2 just below the bend, and 2 at the bottom. The 2 lower pairs are more like tabs sliding into slots in the dash. The tabs are parallel to the lower surface of the vent fascia. So they are disengaged by pulling the lower edge of the vent up and towards you at 45 degrees, parallel to the lower dash/vent surface - not by pulling the vent away from the dash. However, I'm not sure whether it's easier to do it that way or to disengage the top two clips.

I don't know how similar the inner vents are.

 

read the CANVIEW instructions. there is a post by a stereo guy that eflier uses that describes how to diassemble the entire dash... only go as far as you need to and then reverse the steps. on that piece you did it the right way. it snaps into place and for me when i installed my CANVIEW, that was the toughest part by far since you simply push down on the top and pop the thing off. i was afraid of breaking the piece and the force required was a lot. finally after a bit of frustation from trying to ease it off, i just yanked at it and it popped right off.

 

http://www.chrisdragon.com/downloads/Stere...us,%20v1.03.pdf

Hope that helps.