1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Help needed pulling wires through the rear hatch into the car

Discussion in 'Gen 3 Prius Accessories and Modifications' started by rrolff, Sep 25, 2009.

  1. rrolff

    rrolff Prius Surgeon

    Joined:
    Aug 19, 2009
    1,610
    246
    0
    Location:
    So Cal
    Vehicle:
    2010 Prius
    Model:
    III
    I'm trying unsucessfully to run a wire from the hatch to the car (for rear camera) - I have fish tape, but getting through there is a bear - any suggestions?

    TIA

    I'll post pics when I'm done (already installed the cam - just needing to move the cam signal).
     
    #1 rrolff, Sep 25, 2009
  2. dwhutch

    dwhutch New Member

    Joined:
    Sep 7, 2009
    41
    8
    0
    Location:
    Los Angeles
    Vehicle:
    2010 Prius
    Model:
    V
    Is the camera located on the hatch door? Generally in cars if you remove interior panels you can follow an existing harness. Since most use split plastic conduit you can tuck the wire inside. Fish tape in cars has not been too helpful for me. It would be good to see some pictures of what you are trying to do.
     
    #2 dwhutch, Sep 25, 2009
  3. rrolff

    rrolff Prius Surgeon

    Joined:
    Aug 19, 2009
    1,610
    246
    0
    Location:
    So Cal
    Vehicle:
    2010 Prius
    Model:
    III
    On the hatch door, means you must route the cable through a small rubber grommet thing between hatch and car - and I can't figure it out (????????)?

    I can't be the only one???
     
    #3 rrolff, Sep 25, 2009
  4. atfsi

    atfsi New Member

    Joined:
    Feb 18, 2007
    91
    96
    47
    Location:
    03841
    Vehicle:
    2010 Prius
    Model:
    II
    Gave up on that one...used the wireless PEAK backup camera....only had to go as far as the wiper motor for power...
     
    #4 atfsi, Sep 25, 2009
  5. rrolff

    rrolff Prius Surgeon

    Joined:
    Aug 19, 2009
    1,610
    246
    0
    Location:
    So Cal
    Vehicle:
    2010 Prius
    Model:
    III
    Yes - it would seem that's an easy way - but many have done this, I just can't get details.... I'm close, and hope to finish my install this decade :rolleyes:
     
    #5 rrolff, Sep 25, 2009
  6. ALL_600D

    ALL_600D New Member

    Joined:
    Jun 27, 2009
    70
    25
    30
    Location:
    San Diego
    Vehicle:
    2010 Prius
    Model:
    II
    I routed my Sirius antenna wire through the same grommet. I will take pictures of how the wire is routed. It's dark out right now so pix should be up by tomorrow noon/afternoon. It also depends if your camera wiring has RCA's. If so, it's going to be a tight fit. The plug end of the SIRIUS antenna is a little big itself but I managed to pull it through.
     
    #6 ALL_600D, Sep 25, 2009
(You must log in or sign up to post here.)