Has anyone raised the front and put it in "D"?

Discussion in 'Generation 1 Prius Discussion' started by bwilson4web, Sep 18, 2015.

  1. bwilson4web

    bwilson4web BMW i3 and Model 3

    Joined:
    Nov 25, 2005
    27,793
    15,721
    0
    Location:
    Huntsville AL
    Vehicle:
    2018 Tesla Model 3
    Model:
    Prime Plus
    One of my thoughts is to spoof MG2 to the car so I can trick the inverter into generating a 120 VAC, 3-phase and/or two, 120 VAC, 2-phase power outputs. One of the first tests is to see if the car throws a code if the front is lifted off the ground, rear wheels blocked, and put the car in "D".

    Does it throw a code?

    Before running the experiment, I thought I'd ask,
    Bob Wilson
     
    #1 bwilson4web, Sep 18, 2015
  2. valde3

    valde3 Senior Member

    Joined:
    Jun 28, 2014
    2,002
    745
    0
    Location:
    Finland
    Vehicle:
    2004 Prius
    Probably not very helpful but with gen 2 in maintenance mode you can do that and it doesn’t cause codes.
     
    #2 valde3, Sep 18, 2015
  3. E46Prius

    E46Prius Active Member

    Joined:
    Aug 3, 2015
    314
    219
    0
    Location:
    Costa Mesa
    Vehicle:
    2015 Prius
    Model:
    Three
    It'll likely illuminate a traction control light due to the relative speed difference of the front and rear wheels. But that's not a big deal. It'll disappear after a short drive.
     
    #3 E46Prius, Sep 18, 2015
  4. 3prongpaul

    3prongpaul Hybrid Shop Owner, worked on 100's of Prius's

    Joined:
    Jul 18, 2010
    954
    724
    1
    Location:
    Boulder Hybids, Boulder, CO
    Vehicle:
    2006 Prius
    Model:
    N/A
    ABS will code but I'm pretty sure the wheels will keep on spinning.

    Use this http://amzn.com/B000XSEBEK if cruise control disables itself because wheel speed sensors not reporting properly.
     
    #4 3prongpaul, Sep 21, 2015
(You must log in or sign up to post here.)