1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Has anyone adjusted their engine/transmission mounting points?

Discussion in 'Gen 3 Prius Accessories and Modifications' started by Priipriii, May 15, 2023.

Tags:
  1. Priipriii

    Priipriii Member

    Joined:
    Aug 14, 2022
    221
    61
    0
    Location:
    USA
    Vehicle:
    2013 Prius
    Model:
    N/A
    I am looking to swap engines, but if im going to go that route, i might as well do a lift as well since I always wanted one on the prius.

    I want to move/cut/weld the mounting points lower. The whole purpose of doing this is to keep the driver side axle rod straight and not at a steep angle when lifted. Is this doable or am i over my head here?
     
    #1 Priipriii, May 15, 2023
  2. Leadfoot J. McCoalroller

    Leadfoot J. McCoalroller Senior Member

    Joined:
    May 12, 2018
    7,427
    6,913
    1
    Location:
    Pennsylvania
    Vehicle:
    2018 Prius c
    Model:
    Two
    I'd think a couple extra axle joints over the life of the vehicle would be cheaper and less work than re-doing the mounts and potentially having to elongate several wire harnesses and coolant plumbing runs.
     
    #2 Leadfoot J. McCoalroller, May 15, 2023
  3. black_jmyntrn

    black_jmyntrn Senior Member

    Joined:
    Oct 23, 2020
    1,374
    350
    3
    Location:
    Los Angeles, CA
    Vehicle:
    2013 Prius Plug-in
    Model:
    Plug-in Advanced
    #3 black_jmyntrn, May 16, 2023
(You must log in or sign up to post here.)