1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Grinding Noise while Braking, Trans?

Discussion in 'Gen 2 Prius Technical Discussion' started by bailor, Nov 27, 2018.

  1. bailor

    bailor Junior Member

    Joined:
    Apr 20, 2016
    17
    2
    0
    Location:
    Southern California
    Vehicle:
    2007 Prius
    Model:
    II
    There are a lot of threads about grinding noises while breaking but I haven't found anything similar to what I'm experiencing yet, So here goes.

    2007 Prius, 304,000 miles. No rust on discs, pads are at about half life. No noise while braking at 35+ mph. Below 35 mph it starts grinding. Sometimes it doesn't grind at low speeds? I'm at a loss.

    I've read that the transmission could be failing but there are no lights on the dash and it still drives completely normal.

    Any ideas?
     
  2. Skibob

    Skibob Senior Member

    Joined:
    Sep 14, 2018
    2,912
    1,497
    0
    Location:
    Northern California
    Vehicle:
    2006 Prius
    Model:
    N/A
    Get up to a higher speed and put it in neutral and hit the brakes. In neutral the car only uses the regular brakes, no regeneration braking. Let us know what happens.
     
    SFO, bailor and bisco like this.
  3. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    110,166
    50,060
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    tranny doesn't always throw codes, can you post a recording?
     
    bailor likes this.
  4. bailor

    bailor Junior Member

    Joined:
    Apr 20, 2016
    17
    2
    0
    Location:
    Southern California
    Vehicle:
    2007 Prius
    Model:
    II
    When I get up to speed, put it in neutral and hit the brakes, the sound is still there. I'm hoping that's a good sign.
     
  5. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    110,166
    50,060
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    yeah, should be all pads in neutral as bob said.

    maybe jack up each wheel and spin, while someone applies the brake
     
    bailor likes this.
  6. bailor

    bailor Junior Member

    Joined:
    Apr 20, 2016
    17
    2
    0
    Location:
    Southern California
    Vehicle:
    2007 Prius
    Model:
    II
    Thanks guys!
     
  7. Skibob

    Skibob Senior Member

    Joined:
    Sep 14, 2018
    2,912
    1,497
    0
    Location:
    Northern California
    Vehicle:
    2006 Prius
    Model:
    N/A
    Can you tell what side the sound is coming from?
     
  8. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,525
    8,429
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    It could be a bad axle making that sound. Transaxle problem would be a whining sound
     
  9. edthefox5

    edthefox5 Senior Member

    Joined:
    Jul 25, 2007
    10,096
    4,817
    0
    Location:
    Clearwater, Florida
    Vehicle:
    2007 Prius
    Model:
    Two
    Could be the trans there's been a few failures of the differential section. Thats strictly mechanical and would not throw any codes.

    I'll tell you what I tell everyone who has something like this but I doubt anyone follows my advice.

    Get the car up on a lift and change the trans fluid only because you want to harvest the fluid and look carefully at it for bits of metal etc.
    if the axle has failed it will be nasty in there. And you can check and see if its low or out of fluid. Take the fill bolt out and stick your finger in there. Should feel fluid.
    Fluid may leak out of the inner cv joint seal where both inner's exit the diff section of the trans. If the side of the diff is wet with red fluid from leaking seals then you know. Seal failure is caused by bad vibrating inner joints beating up the seal. Seen a few here on that also.

    The trans dump bolt is magnetic so if you see a chia pet hanging off it well then you know some metal is getting eaten up in there. If fluid looks good nice and clean throw 4 quarts of WS fluid back in and go on your way.
     
    Skibob, Raytheeagle and JC91006 like this.
  10. deces

    deces New Member

    Joined:
    Nov 27, 2018
    8
    4
    0
    Location:
    Tucson, AZ
    Vehicle:
    2007 Prius
    Model:
    II
    I had a clunking noise while I used the brakes a few years ago, I never figured out what it was & its gone now. Good luck!
     
  11. TeeTee97

    TeeTee97 Junior Member

    Joined:
    Feb 15, 2018
    14
    3
    0
    Location:
    20011
    Vehicle:
    2004 Prius
    Model:
    Two
    I have a 2004 Prius and had a grinding noise when braking at low speeds. It turned out to be that a screw had come out from the wheel area. I don't know much about cars but my mechanic had put the car on the lift to check to see if my brakes were bad and he noticed the missing screw. Not sure if this is your problem but it wont hurt to check. A part of less than one dollar could have had a bad outcome. Hope this helps.
     
  12. NortTexSalv04Prius

    NortTexSalv04Prius Active Member

    Joined:
    Nov 14, 2009
    915
    115
    0
    Location:
    Texas
    Vehicle:
    2004 Prius
    Model:
    N/A
    FYI/IMHO
    Okay front brakes are a straight forward inspect and repair ….plenty of public comments and how to on that topic....

    Transaxle/Transmission harder to inspect and detect ….Lusc Garage made comments on final drive failure
     
  13. 05PreeUs

    05PreeUs Senior Member

    Joined:
    Oct 1, 2016
    1,097
    563
    0
    Location:
    MSP
    Vehicle:
    2005 Prius
    Model:
    N/A
    Did anyone check the REAR brakes?