1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Factory EV Button Confusion

Discussion in 'Gen 2 Prius Accessories & Modifications' started by DanCole42, May 2, 2005.

  1. DanCole42

    DanCole42 New Member

    Joined:
    Apr 19, 2005
    24
    2
    0
    Location:
    Arlington, VA
    So I read the Factory EV Button Install, but there's one thing it doesn't make clear - I'm hoping someone can help.

    On the factory EV button are four metal contacts that are supposed to plug into the homemade wiring harness. My question is, from the top of the switch to the bottom, which one goes to what? I.e. which contact goes to the ECU, which goes to the ground, etc.?

    Thanks!
     
    #1 DanCole42, May 2, 2005
  2. finiyon

    finiyon Re-Member

    Joined:
    Mar 25, 2005
    66
    1
    0
    Location:
    Philly, PA
    Vehicle:
    2008 Prius
    If you get it wrong, you will have my avatar. :oops: Other than the total humiliation, no other damage was done.
     
    #2 finiyon, May 4, 2005
  3. HTMLSpinnr

    HTMLSpinnr Super Moderator
    Staff Member

    Joined:
    Dec 8, 2003
    5,341
    920
    251
    Location:
    Surprise, AZ (Phoenix)
    Vehicle:
    2018 Tesla Model 3
    Model:
    N/A
    I double checked to make sure it's there (given that I wrote it... )... it is. About 1/2 way down, I list the pinouts.

    I believe the numbers were stamped into the plastic. If not, use a multimeter or continutity tester at low voltage to discern the two. Good luck!
     
    #3 HTMLSpinnr, May 4, 2005
(You must log in or sign up to post here.)