1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Emergency Responder info

Discussion in 'Gen 3 Prius Main Forum' started by Jason762, Sep 4, 2009.

  1. Jason762

    Jason762 New Member

    Joined:
    Sep 4, 2009
    2
    0
    0
    Location:
    CT
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    I am looking for emergency responder information regarding the 3rd generation Prius. I'll run off a quick list of items if anyone has any answers:
    1. Release date of the Emergency Response Guide (ERG)
    2. Routing of the wiring for the solar panels
    3. Voltage created by the solar panels
    4. Disconnecting power from the solar panels to the ventilation fans.

    Thanks in advance
     
    #1 Jason762, Sep 4, 2009
  2. efusco

    efusco Moderator Emeritus
    Staff Member

    Joined:
    Nov 26, 2003
    19,891
    1,193
    9
    Location:
    Nixa, MO
    Vehicle:
    2004 Prius
    Model:
    N/A
    #2 efusco, Sep 4, 2009
  3. efusco

    efusco Moderator Emeritus
    Staff Member

    Joined:
    Nov 26, 2003
    19,891
    1,193
    9
    Location:
    Nixa, MO
    Vehicle:
    2004 Prius
    Model:
    N/A
    Sorry, the link I gave apparently does NOT have the 2010...odd.
    Also, I believe there is a switch in the cabin to turn off the solar vents.
     
    #3 efusco, Sep 4, 2009
  4. qbee42

    qbee42 My other car is a boat

    Joined:
    Mar 2, 2006
    18,058
    3,075
    7
    Location:
    Northern Michigan
    Vehicle:
    2006 Prius
    The solar panels are low voltage devices - no more of a concern than the normal 12V system.

    Tom
     
    #4 qbee42, Sep 4, 2009
  5. Jason762

    Jason762 New Member

    Joined:
    Sep 4, 2009
    2
    0
    0
    Location:
    CT
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    Items 2 and 4 have to do with emergency responder info if the responders have to do a roof removal to extricate a trapped patient. What I was not aware of was that they are low voltage, thus removing any hazard to the first responder. Can anyone say what the highest voltage they operate at is?
    Also I was aware that the 2010 Prius does not have the ERG on the Toyota tech website. My question is when will it come out? Any inside info?
     
    #5 Jason762, Sep 4, 2009
  6. a64pilot

    a64pilot Active Member

    Joined:
    Aug 3, 2008
    771
    62
    0
    Location:
    Albany Ga.
    Vehicle:
    2010 Prius
    Model:
    III
    I'd be surprised (pleasantly) if the solar panel had more current output than a 9V transistor battery. Didn't answer your question, but I can assure you except for possibly a spark igniting fuel or something there isn't enough current to hurt you.
     
    #6 a64pilot, Sep 4, 2009
  7. RobH

    RobH Senior Member

    Joined:
    Sep 18, 2006
    2,369
    981
    70
    Location:
    Sunnyvale, California
    Vehicle:
    2006 Prius
    A data sheet on the KC65T is available at http://www.kyocerasolar.com/pdf/specsheets/KC65T.pdf

    The KC65T is a standard flat panel unit with an aluminum frame, but it is electrically similar to the unit installed on the Prius. The maximum voltage it puts out is 21.7, and the maximum current is 3.75 amp (but not at the same time).

    First responders have a legitimate concern about solar panel installations, as most home units can run 600 volts. But the home units achieve that voltage by stringing dozens of panels in series. A single panel typically operates around 15 volts.
     
    #7 RobH, Sep 4, 2009
  8. John-W

    John-W New Member

    Joined:
    Jul 25, 2009
    14
    3
    0
    Location:
    Canada
    Vehicle:
    2010 Prius
    Model:
    N/A
    Jason

    I would be more worried about the seatbelt pre-tension device in the B post when doing a roofcut. Do a good rip and strip before you make any cuts on a Prius or any modern car. If you still use rams for techniques like a dash roll up be very careful of where you place them. The main high voltage cable runs beside the driver's seat near the rocker panel.
     
    #8 John-W, Sep 5, 2009
(You must log in or sign up to post here.)