1. Attachments are working again! Check out this thread for more details and to report any other bugs.

doing ball joint bushings today 05 277K

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by DGESSWIN, Aug 19, 2017.

  1. DGESSWIN

    DGESSWIN Junior Member

    Joined:
    Mar 29, 2011
    35
    8
    0
    Location:
    Connecticut
    Vehicle:
    2005 Prius
    Model:
    II
    Anybody done this and have some tips? not surprised they went after I replaced the front springs, struts and stabilizer ends. and not surprised both of them went at the same time.
     
    #1 DGESSWIN, Aug 19, 2017
  2. SFO

    SFO Senior Member

    Joined:
    Feb 7, 2017
    5,302
    4,241
    0
    Location:
    Northern California
    Vehicle:
    2007 Prius
    Model:
    N/A
    #2 SFO, Aug 19, 2017
  3. edthefox5

    edthefox5 Senior Member

    Joined:
    Jul 25, 2007
    10,096
    4,817
    0
    Location:
    Clearwater, Florida
    Vehicle:
    2007 Prius
    Model:
    Two
    Pretty sure they are bolted in to the lower control arm so may be able t buy the ball joint separately.
    I have seen very little discussions about ball joints on a g2 so they are very high quality and low failure rate.
    Did they fail catastrophically and the tire collapsed in the tire well?
     
    #3 edthefox5, Aug 19, 2017
  4. DGESSWIN

    DGESSWIN Junior Member

    Joined:
    Mar 29, 2011
    35
    8
    0
    Location:
    Connecticut
    Vehicle:
    2005 Prius
    Model:
    II
    no just clanking and visual inspection shows them being worn
     
    #4 DGESSWIN, Aug 19, 2017
  5. edthefox5

    edthefox5 Senior Member

    Joined:
    Jul 25, 2007
    10,096
    4,817
    0
    Location:
    Clearwater, Florida
    Vehicle:
    2007 Prius
    Model:
    Two
    Yeah the pry bar test does not lie. When they fail it's pretty bad as the wheel collapses in the wheel well.
    But no reports of that on this site.
    Toyota parts are very high quality imho. Which is usually why when I replace anything on my 07 I tend to use
    An original Toyota part. So much after market crap now it's all Chinese and all complete crap.
     
    #5 edthefox5, Aug 20, 2017
    DGESSWIN likes this.
(You must log in or sign up to post here.)