DIY - Front and Rear Brake Change - Questions

Hello Prius Folks!

I'm trying to change the brakes on a 2004 Prius 210k and had a few questions.

General Procedure:

• Park car, have Key Fob in the house (far away from car), remove the 12v battery terminals so that the ABS Actuator doesn't charge the lines, and wait about 5 mins
• Change front brake pads (Pads only)
• Change rear brakes (Shoes, New Hardware Kit [Not needed but wanted to put in new hardware], Wheel Cylinder Rebuild Kit [Not needed but want to have it refreshed], Drums not changed... but should I?)
• Need help to clarify:
  • Once all of the brakes have been processed, I plan to use Techstream's bleeding process so what is the general process to get back on the road?
  • I think this is the general steps but correct me if I'm wrong:
    • Connect 12v battery
    • Bring Key Fob back within proximity, tap the power button twice (without the foot brake pressed as to not turn the car on)
    • Connect Techstream to car and start the bleed process starting from the Front Left, Front Right, Rear Left, Rear Right
• Is all of the above correct?