1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Dash cam fuse - can any empty slot work?

Discussion in 'Gen 2 Prius Audio and Electronics' started by Robertst108, Dec 25, 2023.

  1. Robertst108

    Robertst108 Junior Member

    Joined:
    Mar 5, 2022
    3
    0
    0
    Location:
    Fairfield, IA
    Vehicle:
    2005 Prius
    Model:
    Base
    Is it possible to plug a dash cam power cord with fuse into any empty fuse slot?

    I would prefer to have the dash cam continue to work when the vehicle is turned off. There is an inline device that shuts off the cam when battery voltage drops below a certain level.

    What are the problems, if any, to use an open fuse slot?

    If the power is not continuous, I can keep trying empty slots until I find one that is continuous.

    Thanks for your help.
     
  2. mr_guy_mann

    mr_guy_mann Senior Member

    Joined:
    Sep 3, 2020
    3,668
    1,714
    0
    Location:
    NJ-USA
    Vehicle:
    2006 Prius
    Model:
    Four
    In theory, any empty slot that still has a contact on one side that provides power should work. That said, the 12V in a Prius is pretty small. Even if the camera turns off, it's running the battery down more than normal and will likely reduce battery life "somewhat".

    Posted via the PriusChat mobile app.
     
  3. BiomedO1

    BiomedO1 Senior Member

    Joined:
    Mar 27, 2021
    1,831
    927
    0
    Location:
    SacTown, Ca
    Vehicle:
    2021 Prius Prime
    Model:
    LE
    If this is your daily driver, you probability won't have any problems. Most of those open fuse slots are tied to the accessory circuit, so they're off when the car is powered down.
    I strapped down an aux. gel cell, next to my jack and placed a relay and bypass in the circuit. Anything I want continuously powered is placed on that gel cell. When the car powers-up, relay closes and the gel cell gets recharged. I can manually close the bypass to jump/start the car; hopefully the gel cell isn't too low.
     
  4. ColoradoBoo

    ColoradoBoo Senior Member

    Joined:
    Jul 19, 2019
    1,042
    682
    4
    Location:
    Monument, Colorado USA
    Vehicle:
    2017 Prius
    Model:
    Two
    Yep why introduce a parasitic draw which could end up draining your 12-volt that, already, gets drawn from while the car sits from various electronic systems in the car? When my wife's 2017 sits for more than 4-5 days without being driven, the 12-volt gets pretty low and, if it's not driven, I'll have to put a battery tender on it to bring it back up.
     
  5. Primetime Paul

    Primetime Paul Junior Member

    Joined:
    Aug 7, 2023
    31
    10
    0
    Location:
    San Diego, CA
    Vehicle:
    2006 Prius
    Model:
    N/A
    Hey OP, I just hardwired my dashcam a couple weeks ago, I used the TAIL (Fuse 16) for the constant power and ACC (Fuse 24) for the Switched power. I would advise that you don't use constant recording unless your dashcam has a parking mode. The good dashcams have a parking mode that triggers recording by motion or vehicle movement (shock) to the vehicle. Most good Hardwire kits have a low voltage shutdown at or around 12.0V.
    Also if you're concerned about battery drain, get a cheap Harbor Freight solar panel and charge controller wired to your battery, you can suction cup the solar panel to the rear window and it can trickle charge in the daylight (if you're parked outside).
     
  6. Primetime Paul

    Primetime Paul Junior Member

    Joined:
    Aug 7, 2023
    31
    10
    0
    Location:
    San Diego, CA
    Vehicle:
    2006 Prius
    Model:
    N/A
    I'd like to update this post, The tail fuse is not working for me for constant power. I'm looking for another location will update when I have it sorted out.