1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Can’t get drivers side low beam in

Discussion in 'Prius v Technical Discussion' started by kimpossible, Dec 6, 2021.

  1. kimpossible

    kimpossible New Member

    Joined:
    Dec 6, 2021
    1
    0
    0
    Location:
    NYC
    Vehicle:
    2012 Prius c
    Model:
    Three
    When ever i try to put in this new bulb it never clicks in place. It will just fall out the whole of it will bust and i end up having to buy a new one. How to i get this h11 bulb to stay in place it’s housing
     
  2. rjparker

    rjparker Tu Humilde Sirviente

    Joined:
    Jun 6, 2008
    8,487
    5,052
    7
    Location:
    Texas Hill Country
    Vehicle:
    2012 Prius v wagon
    Model:
    Three
    Use a good light so you can see the opening on the headlight housing. Normally the connector end points down once its rotated about 90 degrees. So you start rotated 90 degrees from the final position. Insert the bulb without the cable to make it easier. Make sure it fits flat and rotate down. Once its in, snap in the cable.
     
  3. Air_Boss

    Air_Boss Senior Member

    Joined:
    Jun 2, 2012
    4,036
    1,110
    0
    Location:
    New Yawk
    Vehicle:
    2012 Prius v wagon
    Model:
    Five
    If you illuminate the low beam lamp housing from the front (outside), you can see the keyed opening as the target and fit the lamp.
     
  4. xliderider

    xliderider Senior Member

    Joined:
    Apr 19, 2012
    7,919
    3,142
    0
    Location:
    Honolulu, HI
    Vehicle:
    2011 Prius
    Model:
    Three
    Also, once fitted, make sure you got it right. Turn on lowbeams and make sure you have a good beam pattern with the usual cutoff and squirrel finder rectangles of light above the cutoffs.

    A bulb that is askew will have a terrible beam pattern and should be corrected pronto or you will melt the plastic mounting area of the headlight housing.

    Posted via the PriusChat mobile app.