BG Hybrid Kit

I used these products for our old 2010 Prius II. They worked well to control oil consumption and I started using them at 125k miles when I started to see oil consumption .

They were not called "hybrid" specific, so I'm not sure what the difference so, maybe just marketing .

But I will use them earlier than 125k miles on our Prime.

So I'll use them and see what data I can collect and share.

 

They are easy enough to add yourself.

Add the epr just prior to the oil change (by sitting in the dealer lot then run your Prius in maintenance mode for 10-15 minutes ).

The 44k treats something like 20 gallons, so I split that between our 2 cars so I don't keep an open can around. But easy to do yourself and ensure it is done right .

 

Wait, does the oil additive go in right before the oil gets dumped out, or do you add it after the change? If so, how do you coordinate the net fill level if two people are pouring things in at different times?

 

EPR is the engine flush (put it in before you change the oil and run the Prius in maintenance mode).

MOA you add with the new oil.

44K you add to your fuel.

 

To avoid the build up, you must use top tier or beyond. Use a very good oil that does not slug. The OEM oil should be good but I use Redline Oil due to high heat So Cal and towing of trailers, I do at times. When engine is fully heated do occasional full throttle runs. Costco gives you 5X EPA additive which is more then any other station at 3X for super at good stations like Chevron or Shell. You can also ad your own like Red line fuel cleaner or Techron from time to time.

 

I wouldn't run the Prius very far.

The one time I did it I was in the dealers lot, added the EPR, Then drove it to the service area for them to then change the oil.

It worked well that one time, then I just did everything myself thereafter.

 

This is what I do. And I run EPR for 20mins.

 

Can you please elaborate on the reasons for the "No driving" caution. Thanks.

 

[Emphasis in the above, mine.] By full throttle runs, do you literally mean flooring the accelerator. Can you tell me the RPM you drive the Engine to when you floor and for how long you keep the accelerator floored (I guess in the highway)?

 

I put the BG Hybrid kit 4 days back in my 2007 Camry Hybrid (which has been consuming about 2 qts oil every 5K) and after a 300-mile trip on the highway yesterday, the oil level doesn't seem to have been disturbed. Too early to tell, but at least no damage. I am keeping my fingers crossed. Will update at the end of 5K.

FWIW, right before this oil change (Valvoline High Mileage Full Synthetic Maxlife 0W-20 + BG MOA), I ran Royal Purple 0W-20 and then Royal Purple 5W-20 which also may have done some preparatory cleaning (although I still saw some consumption) capped off by BG EPR. I put the entire can of BG 44K in the tank (17.2 gal capacity).

EDIT: Edited for clarity and info about Royal Purple.