1. Attachments are working again! Check out this thread for more details and to report any other bugs.

air bag icon

Discussion in 'Gen 2 Prius Technical Discussion' started by donalmilligan089, Jan 2, 2009.

  1. donalmilligan089

    donalmilligan089 Member

    Joined:
    May 16, 2008
    239
    22
    0
    Location:
    virginia usa
    Vehicle:
    2006 Prius
    I recently installed a used Bruno Turn out seat on passenger side And had to revamp the base plate from Dodge to Prius (2005). There is no wiring on Bruno seat . I was able to connect the seat belt wire And no seat belt icon came on. However two more sensors (One for seat back and other for seat bottom) are not hooked up as the sensors are hidden in the prius seat. Therefore a air bag icon is lit. Does this mean that the passenger seat air bag will not deploy. It would be difficult to change these sensors to the Bruno seat. Please help. Don
     
    #1 donalmilligan089, Jan 2, 2009
  2. maseace

    maseace Prius enthusiast

    Joined:
    Jul 12, 2008
    191
    11
    0
    Location:
    Poulsbo, WA
    Vehicle:
    2004 Prius
    Passenger seat side airbag would be non-existent if you removed the stock seat (it's in the seat), and the passenger front airbag would not deploy since the occupant classification sensor is in the stock seat as well (enables the airbag). I'm not sure if any of the other airbags would be affected by this (hopefully not), but the SRS airbag light should stay lit until all connectors and sensors are properly connected.
     
    #2 maseace, Jan 4, 2009
(You must log in or sign up to post here.)